Question about Frigidaire FEQ332E Electric Dryer

1 Answer

Control panel not working

Have a FEQ1442ES1 Frigidaire dryer. We had an electrical storm the other night which resulted in a close hit to the house. I lost two TV's and the dryer ( maybe ). not enough of a hit to trip any breakers. The dryer is getting power ok. the drum light is on and I have checked and all the power wires seem to be ok. Black power wire to motor is hot. Red power wire to panel is hot. Orange/to Peach power wire to panel is hot. However I'm not getting any power on the control panel. None of the light are working, so I cant get any trouble codes. Any suggestions?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,430 Answers

If you have power going into the control but it does not illuminate or respond the control will need to be replaced. Here is a link that should help http://appliancehelponline.com/dryerconsole.html These boards are very sensitive to power surges and are not repairable, they must be replaced.

Posted on Jul 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

FRIGIDAIRE MODEL FEQ1442ES1 LIGHTS FLASH THEN DRYER SHUTS OFF


Hi - From what you have described the unit could possibly have a communication problem with the control board. However, if the unit is producing heat but will not complete cycle please confirmed that the door is closing properly. If it is not, the unit could possibly have a defective door switch or cord/wiring. Either, or, could be faulty at this time. I would suggest contacting a professional to move forward accurately since this is not a typical DIY job.

Oct 13, 2012 | Frigidaire FEQ1442ES Electric Dryer

1 Answer

We have a frigidaire washer dryer combo. after a bad storm (our electric kept flickering off and on) our washer no longer works. we noticed that it would only fill up with water while dryer was on. now it...


Possible damage on the program control panel as it is most likely to be damaged due to a power outage. remove panel and check to confirm if the board is burnt or damaged

Jul 03, 2012 | Frigidaire FLEB8200DS Top Load Stacked...

1 Answer

Dryer clicks when start button pushed but does not start.


A quarter was lodged on the thermal fuse , located below the lint screen on the blower exhaust housing, on our dryer. Remove the front lower panel , 2 screw, and you'll see 2 fuses. I suspect that our control board is burnt.

Aug 05, 2008 | Whirlpool GEW9200L Electric Dryer

2 Answers

Maytag drier model MDE5806AYW


hi thanks for the question i would guess the motor but man thats a hard one if the dryer was hit by lightning it could have caused a fef problems myself i would call my insurance company tell them you were hit before you call the insurance check all appliances in your house you may find other problems thanks the appliance doc

Jul 22, 2008 | Maytag PYE2300AY Electric Dryer

1 Answer

Lightning Storm/Affinity Washer


During a lightning storm, a lightning strike could have induced a high voltage surge in your incoming power lines. Left unprotected from these power surges, the weakest link ( normally low voltage electronic controls) are the most susceptable. Just because you had power available at the wall receptacle after a storm doesn't mean that your washer control system wasn't exposed to one of these surges and got damaged. On the contrary, it is extremely likely that the washer took a 'hit' and was damaged.Other devices plugged into the same receptacle may have survived that hit because electricity travels the path of least resistance.. In this case.. that path may have been thru your washer.. My point being is that your washer could have sustained a power surge and was damaged so don't rule that out. Of course, that surge could have taken an internal fuse or other component out too..

Jul 17, 2008 | Frigidaire Affinity ATF7000E Front Load...

1 Answer

Control panel not working


Measure voltagebetween COM terminal of relay RL2 and neutral.
If 0 volts - defective house power supply or broken wire between terminal block and relay. If 120volts - replace control board

Jan 02, 2008 | Frigidaire GLEQ2152ES Electric Dryer

Not finding what you are looking for?
Frigidaire FEQ332E Electric Dryer Logo

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Tim Whalen

Level 3 Expert

3074 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...