Question about Fisher and Paykel Fisher & Paykel Washer

1 Answer

Getting belt back on dryer

Our belt broke on our gas dryer (I think model number is DG09-US1
I am trying to find a diagram of the belt routing. The company website does not offer anything- any suggestions?

Posted by on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 101 Answers

Try this website www.repairclinic.com/SmartSearch/smartsearch.aspx?SearchText=%60Awashingmachine&gclid=CP_yiYL_8ZICFQHBsgodrEYP5A

Posted on Apr 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Belt routing diagrams


Check with your local Sears Repair Center. They sell repair manuals for various models.

May 06, 2012 | Indesit Hotpoint Creda Tumble Dryer Belt...

1 Answer

I need a diagram on how to open up the back or front to install the dryer drum belt for my Frigidaire FLSE60RGS0. we bought the belt, and I did get a diagram on how to install belt, but doesn't show us...


Disconnect the water, vent duct, and electric connection to gain access to the rear of the machine. Be prepared to catch any water that comes out of the hoses.

On the rear of the dryer, remove the panel that's behind the dryer section (upper panel).

If the belt is intact, make a drawing of the belt's route.

If the belt is broken, remove and discard it.

Slide the new belt onto the drum to approximately where it belongs (lined up with the motor pulley). I think this model might have a groove for the belt where it rides on the drum.

With the slack portion of the belt, squeeze it to make a loop and push it through and onto the tensioner pulley on the bottom of the dryer.

Using the tensioner spring to relax the belt (pull it toward the motor pulley), slip the belt onto the motor pulley.

Check the belt by pulling on it to see if the drum, motor and tensioner are rotating freely (don't pinch your fingers!).

I am not the best at abstract description. I hope this helped.

Good luck from Detroit, MI.

Mar 09, 2011 | Frigidaire FEX831CS Top Load Stacked...

1 Answer

I Have a stackable unit. The dryer had some piece of metal/wire tear off of it. I think it was/is something that held the felt piece in place. I believe it was attached to the back of the drum. I know I...


Take the dryer apart, first unplug it, see what else is broke? how bad does the belt look, the wheels in back? and the front seal? then

Write down the model number and do a google search for your model Maytag? parts. I like partselect.com or repairclinic. both have diagrams of parts you will see what you all need to order.

Remember once you remove any panel you will be exposed to sharp surfaces.

Please repost if you have more questions.

Dec 30, 2009 | Maytag Washing Machines

1 Answer

Need a belt routing diagram for maytag lse7804ace dryer , repaced the drum rollers, belt came off of motor pulleys, can not get on correctly.


not sure how to help u if u have a local appliance parts store in town they would b glade to help u on the back of dryer belt pagages there is a sample haundi24

Oct 27, 2009 | Washing Machines

1 Answer

Replacing the belt on general electric washing machine model WWA7304PML GOT IF OFF TRYING TO PUT THE NEW ONE ON


Go to repairclinic.com and click on the "Repair Help" link at the top of the page. On the following page, look for the "Dryer Belt Diagrams" link under the "Special Features" section. Diagrams M, D, or L under the General Electric section will show how your dryer belt goes back on. If you need assistance in determining how old your dryer is, post your serial number and I can determine for you. I hope this helps you.

Jun 09, 2009 | GE Washing Machines

2 Answers

Can't get Dryer Belt on Kenmore Dryer


Not sure if your dryer is the same, but here's a diagram that may help.
05f55c0.jpg

Dec 12, 2008 | Roper RAS6233KQ Top Load Washer

2 Answers

Diagram of installing belt on amana washer


show diagram on how to install a belt for Amana washer model number ALW410DAW Serrial number 0006303339

Nov 02, 2008 | Amana ALW480DA Top Load Washer

1 Answer

Fisher and Paykel DG09 dryer


Wow, sounds like a major safety issue and possible fire hazzard to me. Try contacting the manufacturer of your unit and do it before the warranty runs out so you have full warranty benefits. Good luck.

Jan 14, 2008 | Fisher Paykel EcoSmart GWL15

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Fisher and Paykel Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...