Kenwood KVT-514 installation

Ozzie my car was burglarized and had my code to my kenwood owners manual now can’t turn my kenwood kvt 514 unit back on can you please help

For safety, the KVT-696, like other 'head units,' is design so that, properly installed, it will only work while the vehicle is in Park, with the parking brake ON. Makes sense if you think about it. Hey?

Try this link. http://www.helpowl.com/p/Kenwood/KVT-514/Research/53126?search=Kenwood+Kvt-514+Update&x=79&y=17

Go into your Setup menu and scroll down to bluetooth settings.

From here you should see a screen that says "HFP connect device", "A2DP connect device" and "Receiver pin code".

Press the "Set" button to the right side of "A2DP" and it should bring you to another screen that says Pair device.

Go onto your phone settings and make sure you have your bluetooth setting on your phone set to "make discoverable"

Press the search button on the Kenwood unit on the right side and it will start scanning for available devices in the vicinity

Also press the Search button on your phone so it also starts scanning.

Next you should get a message on both your phone that shows the Kvt-514 and also a message on the Kenwood that shows either the model of your phone or your "nickname" (if you named your phone)

Select the Kvt-514 on your phone and it will prompt you for the pin code that was on the first bluetooth setup screen...most likely 1111 (you can also set a different pin code using the "set" button to the right side of the "Receiver Pin Code" on the first bluetooth setup screen)

Enter the Pin code and select "Pair" on your phone.

You should get a confirmation on both the Kvt-514 and your phone that they are connected and you're good to go.

it sounds like you are using an amplifier. if so you are probably using the blue wire (antenna remote turn on) instead of the blue/white wire (amplifier remote turn on) to turn the amplifier on. the power antenna remote wire turns off when leaving tuner mode.

you need to purchase the ipod cable... your ipod is connected through the usb cable which does not provide sound to the unit but everything else works

on any of the KVT or DDX model kenwood radios, you can just ground the ebrake wire. which will allow you to watch video and have navi functions while driving. just connect it to the black wire of the kenwood or the metal chassis of your dash.
hope this helps

Hi
Guess your car's wires haven't been cut. Go to any stereo shop and get the harness that's specifically for your car. The colors on it will match all the colors on the clarion harness. Connect like colors, plug in, and you're done.
Please check the below mentioned site for the wiring diagram which will help you for the installation.
http://www.tehnomagazin.com/Auto-radio-car-connector/KENWOOD-Car-Radio-Wiring-Connector.htm

please let us know for further query.
Thankyou for contacting fixya.com.

Go to the kenwood site:
www.kenwoodusa.com\support\
Choose:
Owners Manual

From the drop down menu and select the model you want.
It will give you the choice of 2 pdf files, the owners manual and installation guide. The installation guide has the wiring harness diagram.

go to kenwoods websight and the have downloadable install manuals