Question about Jwin JV-DTV3212 32 in. HD-Ready LCD Television

1 Answer

Jwin 37" tv wont turn on electric went out & not tv wont turn back on

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,361 Answers

Unplug it for about an hour to let it reset itself, if it still does not work, you will have to opne it up do visual inspection and voltage checking, start with the power supply module, make sure it has te standby 5vdc for the porcessot to run.
If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

Parts: www.shopjimmy.com

Please post back what you find

Posted on Jul 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

VW37L 37 in. LCD HDTV input button wont work


Have you find out if the problem is with your remote control? For instance, you are able to control your TV using a Universal remote control. My 32" Vizio TV had a similar problem, initially thought it was related to my remote control but in fact the TV didn't respond either to an universal remote control of my SAT receiver that I eventually use to just turn on and off the TV. I've found out that the problem was with a little board on the TV located at the left down corner viewed from the front side of the TV and that receives the signal from the remote control. I found the board on ebay for about $5, replace it and the TV responded again to both original and universal remotes.

Nov 11, 2013 | Vizio VW37L 37 in. LCD HDTV

1 Answer

My sharp aquos not working tv went off and wont


these flashing lights are error codes set by the manufacturer..
Call sharp...they will tell you the problem

Apr 26, 2010 | Sharp Aquos LC-37HV4U 37 in. LCD HDTV

1 Answer

Our electricity went out and now we have it back on


Most times when a power outages occur, most everything that's plugged into an outlet receives a "Power Spike". Basically it's a shock wave traveling through the neighborhood power grid when the electricity turns OFF and ON.
Hopefully the TV didn't receive too much damage. Inside the TV, there is a fuse that may need to be replaced. Radio Shack or other electronic store will carry these fuses. If this doesn't solve the problem, the Power Supply Board maybe damaged.

Jan 28, 2010 | Polaroid FLM-3734B 37 in. LCD HDTV

2 Answers

42'' lcd turns on no picture/menu


Your tv is being attacked by electrical surges which seem very violent and has already damaged some logic controls. Please invest in a AC filter which will protect your tv from such spikes....... but first you need to get your tv serviced from the electrical damaged it has already suffered.

Nov 02, 2009 | Philips Televison & Video

1 Answer

The car wont go over 35mph....after the motor gets warmed up...has a code 37....help!!!


There should be an electrical connector right by your transmission dipstick. Disconnect it & see what happens & get back to me/us.

Code 37 = part throttle lock/unlock solenoid driver circuit

Aug 08, 2009 | 1988 Chrysler New Yorker

2 Answers

TV wont turn on with power button or remote


Try putting the cables back where they were. After that re-route them again but this time use the manuel.
If that doesn't work, consult the TV's manuel.

Jul 04, 2009 | ViewSonic N3735W 37 in. LCD TV

1 Answer

Philips model 29pt3425-79 flat screen wont switch on


May try to replace your power supply. Average cost runs $200 via Internet. Also may inspect test & replace deformed an or any bulging caps.

Jun 01, 2009 | Philips 37PF7320A 37 in. HD-Ready LCD...

5 Answers

EMERSON EWL3706 37 IN. WONT STAY ON


had same problenm with mine it was a fuse that blew. took repairman 5 minutes to fix charged $136.00

Feb 07, 2008 | Emerson EWL3706 37 in. LCD Television

2 Answers

Problems with Jwin JV-DTV30 30 in. HDTV-Ready LCD Television


This sounds like micro glitch try unpluging the tv and all controlable inputs (PC, iLinks, or other such devices) wait 5 min then plug the tv only in and see if you have returned functions. if you should read the manuals of those devices to see if the control functions can be turned off.

Jan 07, 2008 | Jwin JV-DTV30 30 in. HDTV-Ready LCD...

Not finding what you are looking for?
Jwin JV-DTV3212 32 in. HD-Ready LCD Television Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jwin Televison & Video Experts

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Jaime Hernandez

Level 3 Expert

2326 Answers

romy sibug
romy sibug

Level 2 Expert

269 Answers

Are you a Jwin Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...