Question about Mitsubishi WD-62525 62" Rear Projection HDTV

2 Answers

No picture no sound will turn on but not off, red light comes on

Posted by on

  • striperemove Jul 20, 2010

    i get a 3 4 code thanks in advance

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Assuming you already changed the lamp, then the problem is likely in the lamp ballast or the power PWB in the electrical chassis. Error Code 34 is lamp abnormality. If you end up with a solid red lamp light and then need to unplug the AC power cord and then plug the cord back in so to get rid of the red light? Not sure what you are saying about what not turning off. The power still turned off when the red light came on? I assume the red light is a solid red lamp light and not the status light?

then check the following.

Take a look when you turn on the TV, does the lamp come on for about 10 seconds and then turn off? If so, check the power PWB first to see if any of the electrolytic capacitors are bulging.

If you have not done so yet, you should get the service manual for your TV model to see how to disassemble the parts.

Good luck

Hank

Posted on Jul 22, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 8,617 Answers

When the red light is lit press both the menu and device buttons in on the front of the set in together and hold for 5 seconds then record the two digit blink code that will repeat. I am assuming you will receive a 34 error or a 41Error. But let me know what blink code you get and I will assist you.

Posted on Jul 20, 2010

  • Sonny Berry
    Sonny Berry Jul 20, 2010

    Okay, The 34 error code indicates a lamp abnormality. But if your lamp light never turned yellow Its most likely not the lamp. I would suspect bad caps on the power board. there are (2) 3300uf, (2) 2200uf, and (4) 100uf radial capacitors that are prone to fail. Replacing them will most likely fix the issue. If you need more assistance let me know.

  • aolivera69 Jun 26, 2011

    I HAVE THE SAME PROBLEM BUT MY TV TURNS ON BUT NO PICTURE AND I HEAR A NOISE COMMING OUT OF THE BACK OF THE TV

×

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

djnick989
  • 1067 Answers

SOURCE: my toshiba wont turn on but red light come on an green light flashing no picture or sounds

yes ill got remote link for u here give me one sec

Posted on Jan 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maganavox flat screen tv no pic, red light blink codes...


Those blinks are fault codes. To know more visit the site linked here. http://electronicshelponline.blogspot.com/

Mar 25, 2017 | Televison & Video

1 Answer

42 inch Akai plasma - no pix no sound


i think your power board has some serious problem

May 21, 2008 | Astar LTV-2701 27 in. HD-Ready LCD...

1 Answer

LG rear projection tv. sound but no picture.


Go to a repair centre, some parts must be fixed/replaced.

Jul 22, 2009 | LG RU-52SZ30 52" Rear Projection...

4 Answers

Tv tunrns on then goes to stand by flashes 4 times & repeats


turn tv on picture comes up 2to3 seconds later tv blacks out then stand by red light flashes 4 times in a row repeatedly..can not turn on or off when stand by light starts flashing but before tv blacks out you can turn tv on and off repeatedly and picture and sound work.You have to unplug power cord for 30 seconds after stand by light comes on to get tv to turn on.

Mar 13, 2009 | Sony BRAVIA KDL-32S2000 32 in. LCD HDTV

1 Answer

Red Lights on the Power button blink and picture goes dark


60PL9200D/37 When I unplug it for a while and turn it back on, the picture starts to come on, but it turns dark. And the red lights on the left and right side of the power button blink. Sound but no picture.

Feb 02, 2009 | Philips 60PP9202 60" Rear Projection...

1 Answer

Picture wont come on screen


this problem is in the power supply.the red lights indicate as the standby mode.

Jan 23, 2009 | Sony FD Trinitron WEGA KV-36FS120 36" TV

5 Answers

No picture but has sound


My LG TV
switch on no picture but short period of sound then nothing

Jan 20, 2008 | Sony KP-51HW40 51" Rear Projection...

1 Answer

Tv's red light comes on but no picture or no sound


Solder any / all bad connections
Check horizontal, vertical and power circuitry with meter...
might need service manual...................T.

Dec 12, 2007 | Toshiba CF36H40 TV

1 Answer

Tv will not come on


Sounds like the bulb is blown.

Oct 05, 2007 | Toshiba 52HM95 52" HDTV Projection...

Not finding what you are looking for?
Mitsubishi WD-62525 62" Rear Projection HDTV Logo

531 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1244 Answers

The Knight
The Knight

Level 3 Expert

75963 Answers

Jaime Hernandez

Level 3 Expert

2337 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...