Question about Zanussi FLA1201W Front Load Washer

1 Answer

Zanussi 1210 Front Loader

Hi

I've got a problem with my Zanussi 1210 front loader washing machine. The belt broke, and got wrapped about the shaft. I've removed that, but it has unfortunately pulled out two wires - a red and a grey. I can find the majority of the wire coming down from the top, but I can't find where they attach to. Do you have a wiring manual for this model, or a similar model that would be suitable?

Thanks,

Daniel

Posted by on

  • 1 more comment 
  • kev82 Oct 23, 2008

    I have the same problem, On mine 2 white wires, have broken totally off. Both are connected to the motor harness, one to a light green wire, right on the end of the connector. and the other to the yellow wire next to it. The other ends of the white wires go to a cct board at the top of the machine. The connector to the cct board has two orange wires at one end and six white ones.Taking the first orange wire as wire 1, then ones that are cut are to wires 6 and 8 on that connector. The problem is I don't know which way round to connect them.

  • Anonymous Feb 28, 2009

    I have the same problem except in my case it pulled off the two orange wires going to the thermostat, cannot identify where they feed from

  • jking12 Feb 28, 2009

    I have a similar problem except in my case the belt pulled off the two orange wires to the thermstat, cannot identify where they feed from

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem (kev82) can't see a red wire though on mine, Two gray wires though on mine connect to two wire connectors just above the motor. There are 3 connectors near each other. One for the 1st gray wire, the 2nd for a green/yellow wire and the 3rd for the other gray wire. They all seem to be connected to the side of the drum. Hope this helps

Posted on Oct 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung wf8750lsw front loader door wont open


Not sure if you mean when it is fully off or operating, but if you mean that once it is operating the door won't open, then the following applies...

Once a front loader wash cycle starts, the door on a front loader is physically (electronically) locked until the full cycle ends after spin dry. This is to prevent anyone opening the door and letting all the water out in the middle of the wash cycle, which a lot of people try to do to put in more clothing etc.

Apr 11, 2014 | Zanussi F1045W Front Load Washer

1 Answer

Washing Machine leak underneath the machine - Zanussi FLS-579C


have checked the door seal
send the 91------------- no this is on a label in the door

Feb 05, 2014 | Zanussi Washing Machines

1 Answer

Hi! My 7kg Samsung J843 Front Loader Washing Machine is not spinning at all. Makes a whirring sound but no movement. Any tips?


Hi, I've had this problem before. It was a while ago but it was either a broken belt or the belt had slipped from the correct position and needed to be put back on. It was under warranty and a service tech fixed it.

May 08, 2011 | Samsung WF337AA Front Load Washer

1 Answer

Replace belt j845 samsung front loader washing machine. how do i get replacement belt on as back and both sides of machine is one piece of metal


There is no belt on a front loader washing machine. The way the drum spins is by a stator in the back of the unit.

Dec 29, 2009 | Samsung WF337AA Front Load Washer

1 Answer

Sulphur like smell when washing the clothes


something not well with motor, like belt or clutch slipping. or motor overheating. you could use the machine until something fails, but i would not leave the house with the machine running.

Aug 09, 2009 | Zanussi ZJD1219 Front Load Washer / Dryer

1 Answer

Door not locking and program reverting straight to end


initially i would replaced the door interlock then if no result the control boart could be faulty.

Mar 13, 2009 | Zanussi ZWF1430W Front Load Washer

2 Answers

Belt broke how do i get to it


dear afcwoboy_02,
u can contact the authorised service centers.they wilhave spare parts. else tel me from which part u are from. i'l tel the nearby service centers..

Sep 05, 2008 | Washing Machines

1 Answer

Zanussi Front loader washing machine


is the door loose( up/down movement) could be hinge problem,or the door lock may need replacing.

Mar 20, 2008 | Washing Machines

1 Answer

Westinghouse 798 front loader 7kg washing machine


God Sir

I am mr Yapi Antione from abidjan i am dealing with all washing marshing i saw your profle and i am intrested to to know the pris list of all the marshing in your company
i will like to haer from you as soon as posible

yours representetive
Mr Yapi Aantoine
you can reply me in this my email adress

yapiantione@yahoo.com
Or
Call me 0022501307526

Apr 04, 2007 | Zanussi FJS1225W Front Load Washer

Not finding what you are looking for?
Zanussi FLA1201W Front Load Washer Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Zanussi Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Zanussi Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...