Thers a niose when i turn my car on

sounds like could possibly be a wiring issue have u checked all the wiring for that blinker

the way i reset the antitheft is to put the key in the ignition and turn it on till all the dash lights come on but dont start it let it sit 15 minutes turn the key off and turn it on again till all the lights come on again repeat this procedure three times after the third time turn the key off for about 5 seconds and then your car should start hope this helps.

scan the codes may be able to reset comp and all will be fine being stuck could have set some codes dont replace anything till you try clearing codes

look for a low amperage fuse, either in the fuse box or behind the radio, probably called memory or somethingh

Does this key have the little black chip in it if it does take an emory file and touch up the sides of the chip and retry. If it does not have the chip in the key check the ignition switch on the bottom of the column. The easiest way to check this is to take a volt meter and find the small wire on the starter solenoid and have someone turn the key to the full start position and see if you are getting atleast 12 volts to the solenoid wire. If you have the chip and this does not work possibly need to have the security system checked could be causing the problem.

Generally, the maintenance light should come on for a few seconds, then go off after the car has started. All of the dashboard warning lights do this so driver can tell they are operational. (Should see brake light, low oil pressure, airbag warning, etc. Any of the lowly "idiot" lights should come on.)

As a test, turn the key on, but not to start. All of the lights should flash on for a few seconds, sometimes in sequence, then go out. Now, sart the car, some lights may come on and back off. If none stay on after a few seconds of engine running, you are probably ok.

If it seems to be coming from the rear, usually an internal differential problem.

I had a wire connector on the front of the engine that had so much tension, the wires broke. I didn't notice until a wet day when the car wouldn't start (and the Check Engine light was on). (The error code was related to an Emissions error.) The connector is located on the engine, front, just left of center. Hope this helps!

The dash switch is bad, press it several times until it turn off, if definitely it don't turn off go to technician to fix it or remplace.

Sounds like a bad brake switch. It has a shift interlock system that requires power from the brake switch to move the shifter.