How can i have the errors on my computer fixed at no cost to me

That is a general printer error. Ensure that the cables are properly connected; you need to ensure that your printer is properly connected, and plugged in, and also the cable is accurately connected to the computer as well. Check the power; make sure that the printer's power is switched on, ensure that all the computer necessary computer components are also turned on. Make sure that the hardware is properly plugged in.

you must have something wrong with your computer regersty. I would deep clean your computer with regcure or whatever you like. Its seem you have a hiden problem in your Operating system with that only good software will fix it. I get my soft for free on thepiratebay.org. I use Advance Systemcare Pro. It usally cost like 39.99 but you can free on thepiratebay.org. It works great and fixs everything in my computer that i didn't know that i had in my computer. I had 40,000 Errors and 2 virus that i didnt even know that i had. And My Anti-virus is Norton 360 didnt even pick it up. So try Advance System.

Hello

Unfortunately an "error 322" message is not something that you will be able to fix. This error indicates a system failure and requires the camera to be sent in for servicing and repair.

You may find it more cost effective to purchase a new camera as opposed to the repair price on your current camera.

Hello
You can get detail help of this error from HERE
Hope this helps

main computer board then once you get it fixed put it on a surge protector it just like your computer,part cost about 100 to 150.00

A system error indicates a possible software or firmware problem. If the unit is in warranty, contact Toshiba about a software upgrade (possible).
If it is out of warranty, the cost of repair is likely more than a new unit.

A system error can be caused by moisture (#1), physical damage (#2) and a possible software update issue. Your Toshiba Gigabeat Room software for your computer may be able to get upgrades for your MEG-F10K. Check the owner's manual. If you cannot connect to the unit with the computer to transfer songs and movies, it is likely not repairable for a reasonable cost.

Machine error 50 is a error in Purge unit.You can't fix it by yourself and your printer need service.In most case the cost of repair is more than cost of new printer.

A 41 error is your throttle positioning sensor, its a electrical sensor hooked to your injectors telling them how much gas/air to be releasing as u accelerate/deccelerate. Best and only way to fix it is to buy a new sensor. Then reset the cars computer at a diagnostics shop for little or no cost.

i put mine in the shop it is the laser and it cost $219.00 for the part because it comes in an assemlby piece it depends on how much they charge for labor. I choose not to fix due to high cost of it all it is in a bag besid emy computer

can you provide the error message, depending on the error and if you want to attempt to repair it yourself? Printers are like computers these days you can almost replace it for the repair cost, but if you will provide a error code we can see what we can do.