Question about Sony KP-53V45 53" Rear Projection Television

1 Answer

Standby light flashing

Stadby light flashing

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 129 Answers

Try connecting the TV directly to a different wall outlet and check. If the issue persists, try power resetting the TV. Turn Off the TV and remove the power plug from the wall outlet for 1 minute and reconnect it and check the operation. If the issue persists, then the TV requires service.

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My samsung tv stadby light is blinking capacitors look good on power supply


It may be the eprom (memory ic) is corrupted and needs replacing it is a job for an engineer

Apr 10, 2017 | Samsung Televison & Video

1 Answer

My lcd tv wont come on but the stadby light is on ?


Hi.

The TV starts in forced standby. The state is also called "Protect Mode". Protect mode kicks in whenever an internal fault is detected. The error is detected by controller circuit and the PSU is forced in standby mode, shutting down all voltage lines apart 5VDC to keep standby on.

First try disconnecting the power cord for ten minutes, reconnect after ten minutes and restart the TV with no device connected.

If that does not help it means that there is an internal fault and that the TV must be tested and repaired replacing the defective part.

The defective part is usually the PSU. Among components that fail quite commonly there are the capacitors on the power board. If the capacitors look swollen or if there is trace of damage on PSU board, then the affected parts must be de-soldered and replaced. If there is no evidence of damage at a glance the parts must be tested using a multimeter and following schematics from service manual.

If you need to call a technician use the phone number listed on the owners manual or on the manufacturer support web page.

Regards.

Ginko

Jul 20, 2011 | Samsung LA40A450 40 in. LCD TV

1 Answer

Stadby light comes on for30 seconds then just keeps flashing nothing eles happens


Unplug unit for a couple of hours. That may reset any problems it may have.

May 09, 2011 | Televison & Video

1 Answer

Cannot get my new crosley out of standby mode. which button do you push as there is no standby button?


When it is off and plugged into the wall outlet the standby light will be on. The stadby light will go off when power button is pressed. If not there is poblem that needs service.

Dec 26, 2010 | Crosley CR78CD-P CD Shelf System

1 Answer

I can't get the printer to go on standby


unplug the printer and press the ON BUTTON then insert the plug.again press the ON button 1 more time.it will start moving and come to the position.

Nov 29, 2008 | Canon PIXMA MP460 All-In-One InkJet...

3 Answers

W890i just keeps crashing and going into standby mose with red light on


I had the exact same problem. Solution is to update phone via sony ericsson support site. Ensure you have backed up your phone first as alll numbers and ms will be lost. I have had no problems since the update 10 days ago

Oct 15, 2008 | Sony Ericsson W890i Cellular Phone

4 Answers

Flashing red light


I think this sounds like my problem (need to replace the projector lamp). However, when I hit the "on" button, my SXRD 50" blinks green for about a minute then starts blinking red. Can you confirm the bulb solution? I was very pleased with this sight when my fan malfunctioned. I got the fan in a matter of day's from Sony and it fixed that problem.

Oct 29, 2007 | Sony KDS-R60XBR1 60" Projection HDTV

1 Answer

Sony kdl 32 inch lcd tv (apprx 2.5 yrs old)


Usually resetting a device like that is done via it's On Screen Display (OSD). Maybe you need to contact Sony Tech support.

You can do this by clicking the below link:
[Sony Tech. Support]

Let me know if they have a solution to your problem.

Greetings,

DarkNeogen

Aug 20, 2007 | Sony WEGA KDL-32XBR950 32 in. LCD HDTV

Not finding what you are looking for?

Open Questions:

Televison & Video Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75756 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...