HOW DO I OPEN TO REPACE BATTERIES - Motorola Talkabout FRS 250 (14 Channels) 2-Way Radio

Hi valentin 201
I have owned my own business for 3 years and have been working on scooters and powerchairs for 15 years. . In the future give as much info about the scooter as possible.

1. load test the batteries even if you think they are good, check anyway. Sometimes even new batteries won't hold a charge.

2. Your charger on the powerchair must have enough volts to open the charger inhibitor. That is, the charger won't even start up if your batteries are low. Both batteries need to have at least 20-22 vdc.

3. Some chargers have a 3amp fuse check that and repace if needed.

4. With a multi meter set on dc200 check your batteries. Red on one battery and black on the other. Check to see what you get for voltage. If no voltage reverse the lead wire to the other posts. Once you get a reading of 20+ volts watch the meter and plug in the charger, it should increase the volts on the meter. if not the charger is bad, replace. Charger should be 24-31 volts to be a good charger.)

One of these sugestions will fix the problem

Good Luck
Tim

Of course you first tried replacing batteries in the remote? If so, take the remote to a TV repair shop and have them test that it's sending a signal. If it is working you'll have to open the unit and hook an o-scope (a good sensitive voltmeter may also be sufficient) to the IR receiver and see if you're receiving the signal. If that works there should be a signal line to send the command to the micro. This is usually the same line the keypad uses. Test individual components according to your results or simply repace the IR board if you're missing that signal. If you don't want to test anything you can just try replacing that board anyway. Good luck.

The batteries don't last long if they are on charge all of the time. I would repace them and only charge the new ones, when flat.

James your scooter use 2 12-12ah batteries located inside the battery case. Just remove the screws holding the case together and remove the old batteries then replace with the new ones making sure that you repace the wiring just as you removed them from the old batteries you might also have a heat sensor attached to one of the batteries make sure you reattach that to the new batteries. Any off board charger made for power chairs or scooters will work but try to find a 4 amp charger with an on/off switch. Always turn the charger off when plugging or unplugging from the scooter Check on e-bay or with a provider for a charger Hope this helps

Repace the tstat. Bad display. Make sure the batteries you put in were good First. Russ

thermostat stuck open repace it

Recharge or repace batteries. Use good quality batteries for Digital cameras.

I dropped the camera on the table a couple of times, twisted the front of it. Suddenly the lens retracted into the camera, the beeping quit, and now I can take pictures again. The Samsung website is horrible.

yea sound slike you ohave a faulty water inlet valve, stuck in open positon,removet he hoses and repace the inlet valve on hte washer.

http://www.repairclinic.com check how to repace it with the schematic diagrams you'll see how