I have a Timex Expedition Analog/Digital. Just replaced the battery. When I first installed the battery and replaced the cover, the watch was beeping steadily and all the digital bars were illuminated and the hands weren't moving. I took out the battery and replaced it exactly the same way and this time the hands worked but the digital face does not, nor does the light. Is there some sort of reset function or something internally that I might have touched that would affect the digital operation?

If It's digital, follow this link. If Analog, pull the crown half way out to move the day and month. How to Set Timex Expedition

This instruction works for Expedition Digital Compass watches also.

Hi,digital and analogue watches have 2 different batteries,I believe you need to replace the battery of the analog part ..just reminder,so save money and time you can replace both at the same time to prevent to replace the other 2 monts later.!Hope this helps! Take care and please Remember to rate/vote for us to continue for Helping out the Community :)
Thanks

Hi, You may know that this watch runs on two batteries, one for digital display and another for analog hands.
If the analog hands stop working all you need to do is to replace the battery and please replace both at the same time since the band and cover take some effort to remove.
You need to take off the both bands first to access the back side than the back cover with a small knife..
Just in case,if you need the user manual here is the link.
Timex watch: http://www.timex.com/info/Product_Instruction_Guides_Downloads .
Take care..
Regards

mcdevito75 here, Look for any indentations on the back cover and case that should be linned up, as an example, a cutout on the cover for the stem, after the cover is linned up place the watch on a sturdy surface crystal up (glass) and with the palm of your hand apply even down pressure to close the back. If you can"t look for a small watch repair shop, they will close the back cover for you.

I think you put case back wrong way ,, or a small spring which connect caseback with watch movement feil during battery change that also ma be a issue.
From
AmFix Jewelry & Watch Repair
203 N. LaSalle St
Chicago, IL 60601
Ph: 312 641 7000
Email: info@goamfix.com
Web: www.goamfix.com

Remove the four screws that hold the battery cover on the back of the watch. Remove the 3 very small screws that hold the battery in place. Remove the battery from the battery holder. The piece that the 3 small screws were removed from seperates from the 3 volt 2016 energizer battery. Replace the battery with a new one. Re-install the battery holder to the watch. There is a small tab on the lower left part of the battery holder that needs to be depressed to activate the watch. Depress it and look at the face of the watch to make sure it is activated. The watch will need to have the time, date etc reset but you should now be able to see that the battery is working. Replace the battery cover and reset the time and date as needed.

good after noon ! maybe the problem of your watch is wrong possition of case back because the speaker or buzzer of your watch is attached on the case back , so open the watch and fix the case back at the correct possition ,!thank you ! god bless !.....

Press all the four buttons simultaneously your digital clock gets resetted. It worked for me try it out.

Here's the inside of my Timex Expedition Dive watch. To reset the watch after replacing the battery, press down with a small screw driver on the metal tab that the red arrow is pointing to.