Question about Heating & Cooling
My Everstar MPM-08CR-BB4 air conditioner is blowing cold then hot air. How do i fix it? It Blows cold air for a little while then it blows Hot air, if you mess with the controls it blows cold again for a bit. It does not dehumidify like it should...I left it on all day and it only got about 1 cup of water in the bucket.
Check your thermostat or battery backup or both..change or replace if necessary..
Posted on Dec 02, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The P1 code means the lower water bowl is full.
Put a pan under it an pull the lower plug (some 10" below the upper drain plug that I hope you have a hose attached to.
Posted on Jul 24, 2009
Make sure the water container is clicked in properly. I found this to display the P1 and flashing red light if the floater switch is not properly engaged.
Posted on Jul 14, 2010
Tips for a great answer:
Mar 15, 2015 | Everstar Portable Air Conditioner Everstar
Jul 07, 2009 | Heating & Cooling
Jun 25, 2009 | Danby DPAC8020 Air Conditioner
Jun 21, 2008 | RIM BlackBerry Pearl 8100
336 people viewed this question
Usually answered in minutes!