Question about AEG Refrigerators

1 Answer

Light inside broken and switch inside has melted.can the fridge still be used,it sounds ok.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,906 Answers

No it is a fire hazard unless you cut the wires to the switch and, wirenut them.

Posted on Jul 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 Subaru Outback parking lights will not shut off and is running down battery what could be the source


Sounds like a bad light switch. The contacts inside have melted / broken and are making contact with the power wire. Pull the switch and check continuity between the power pin and the parking light pin on the switch. You will need a multi-meter and a schematic. If you cannot find a schematic online, join a forum and ask. If that does not work, order a Haynes manual from amazon - schematics are in the back of the book.
If the switch checks out, then look for melted wires in the lighting harness. IF all the parking lights stay on, its a power feed issue more than a bulb or a ground.

Jan 07, 2018 | Subaru Cars & Trucks

1 Answer

Fridge light not working


door light switch Need full model # for better idea .
but normal switch should be at bottom of door or at hing side of ref
some model have at top it may be broke off and thats why you don't see it send us a full model number we will find for you

Feb 28, 2015 | Hotpoint Refrigerators

1 Answer

Ice inside my fridge


Check door seal intact and sealing ok, clean rear compressor section of all dust/ dirt/ fluff and check drain hole on rear of fridge.as water should not pool inside but run away outside rear. Lift/ adjust door to make sure it closes properly.

May 17, 2012 | Samsung Refrigerators

1 Answer

The freezer department is making snow and the vents blocked with ice. now the refrigerator compartment is warm. i have the freezer temp on cold and the refrigerator between normal and colder. what should i...


If the freezer is cold the compressor is Ok. Now if its a two door fridge . Open both the doors while the fridge is On. Press the lower door switch ( the lower light should turn off and you should hear the fan humming sound come on ). While holding the door switch pressed close the freezer door, you should see cold air come out of the slits in the back of the lower compartment. If not icicles have blocked the passages due to the non working of the heating coil.The heating cycle is controlled by the timer switch located near the compressor at the back. Unplug the fridge and remove the timer switch.Note the color of the wires and mark on the old switch. Replace and it will work.Only frost free fridges have heating cycle.

The cold air passage in a modern fridge is made out of thermocole . It will take you more than 24 hours of defrosting to remove the ice. I had to use a hair dryer to melt the ice even after 30 hours. Thermocole is a fantastic insulator.If you want to avoid melting the insulator blow air into the vent from the refrigerator compartment using a vacuum cleaner in blower mode ( reverse mode ). After a few minutes of blowing,hot air will come from the vacuum cleaner which should do the trick

Jun 26, 2011 | Kenmore Top Freezer Refrigerator

1 Answer

Lights stay on inside Sears - LG fridge. What is solution?


sounds like the magnet that detects the door closed has failed

Apr 20, 2010 | LG LRFD25850 French Door Refrigerator

1 Answer

FRIDGE/FREEZER ON THE BLITZ?


Try removing everything out of your fridge, switch it off and open all doors for 12 hrs. Then close doors and switch it on for another 24 hrs before putting in you stuff. most likely the evaporator is iced up, you need to defrost if fully.

May 04, 2009 | Refrigerators

1 Answer

Fridge was "hot" on the inside when I opened


Sounds like compressor out or relays on the compressor out. Is freezer side ok? If so you may have a defrost problem... http://www.houstongofarappliancerepair.com/Refrigerator.html

Dec 02, 2008 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

Light is on but frig stopped cooling


I had a problem with my Viking where the light stayed on in side and was causing havoc with the coling system.
I saved 200.00 doing this.
get a cell phone or a small video camer place it inside the fridge and record to see if the light stays on when the door is closed.
If it does. You may just have a light switch to replace or like I did readjust the push spring that the door hinge hits to active the switch.
Once I did this the light went out and the fridge started cooling normally. the lights will heat up inside the fridge and screw up the thermostat. then the fridge will start to cycle. not good for the compressor.
hope this helped.
good luck

Jun 25, 2008 | Kenmore Refrigerators

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top AEG Refrigerators Experts

Oscar Netto
Oscar Netto

Level 2 Expert

110 Answers

ashburton

Level 3 Expert

417 Answers

Jim Goldsmith
Jim Goldsmith

Level 3 Expert

1906 Answers

Are you an AEG Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...