Question about Krups FLF2 Cordless Electric Kettle

1 Answer

My Krups FLF2 kettle leaks at the bottom of the handle

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

This is a known issue with Krups kettles. If you are a handy person then you can remove the base and use a high temp gasket maker (auto shops have it) to add to existing silicone seal which goes bad after a couple of years.

Posted on Jan 16, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: krups electric kettle leaks

You cannot fix it when they split like that.

Posted on Apr 01, 2010

Obertelli
  • 3006 Answers

SOURCE: krups kettle leaks at base of pot

Unfortunately it's unfixable. A few recent Philips models do it as well and it's worst in hard water areas. Basically the cause is that a tiny bit of water gets into the bottom seam each time the kettle is used and leaves a residue behind when it dries out. Over time, the residue builds up and forces the seam apart so the leak gets worse.

All you can realistically do is hope that it's still under warranty and demand that Krups replace it, preferably with a different model. If they won't then you may have to exert whichever consumer rights exist in your country, but one way or another you need to stop using your kettle (it's dangerous!) and replace it with another.


Posted on May 21, 2010

  • 279 Answers

SOURCE: krups kettle explosion???

go to krupsusa.com customer service

Posted on Sep 18, 2009

  • 1417 Answers

SOURCE: Krups Tea Kettle isn't working. I believe the

hello,

the handle has noting to do with the heater what you need to check on is the connection from the power supply if the connection is alright then you will have consider the element it is the heat provider connected to the wire it means that it is weak it need to be replace with a better one the element is in silver colour you can get it in any technical store/shop around you.

thank you

Posted on Jun 10, 2010

  • 1 Answer

SOURCE: the kettle leaks at where teh handle attaches at

Join the club ---I'm taking ours back this afternoon to BB&B. It's still under warranty and we have the receipt.

Posted on Dec 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My pot has a slow leak. I have tightened all the screws and bolts on the bottom and it still leaks or seeps.


I was successful at fixing my Krups Electric Kettle for $4. In my case the water was leaking from bottom somewhere close to the heating area. I think that a small hole was created in the seal around the heating area in the bottom of the inside of the kettle. One can try to find the general location of the leak by putting a small amount of water in the kettle, place the kettle in a larger pan, and tilt the kettle so that the water is slightly higher than the heating area in one area only noting the position where the water level is the highest. Leave it for a while and check for leakage. If there is none, rotate the kettle a few degrees and look again for leakage from the new area until you find the area where it is leaking. Alternatively you may wish to put a sealant around the entire area, 360 degrees, around the top of the heating area. You will have to remove the strainer first to get your hand in the kettle to apply the sealant.

I went to my local hardware store and looked for sealant that were:
1. Potable (ie safe since you will be using the water for coffee, tea, and other applications that you ingest).
2. That will withstand heat up to at least 250 degrees Fahrenheit. Remember that water boils at 212 degrees.
I found epoxies that required mixing two compounds but decided that this would be difficult to deal with and apply. In the end I bought "PC Plumbing Epoxy Putty" from PC-Products. This met both requirements and was easy yo use. You take the putty and roll it between your finger just like you did in kindergarten with the clay and make a thin string that you could position in the crevice around the top of the heating area. You may either cover the area where you found the leak or the entire 360 degrees. You will note a somewhat foul smell of the putty. The manufacturers says that it will cure in 3 hours. I found that the smell went away when it completely dried and hardened after 3 weeks!.
I will assume that the same solution is applicable to leaks in other areas of the kettle. I have also found that there are equivalent electric kettles much cheaper than Krups. I would certainly check the construction to see if there is one with less of a chance to develop a leak.
But the bottom line is that it cost me $4. I just finished testing the Electric Kettle and it is fine, not leaking, and the instant coffee did not have any bad smell.

Meir Elazar

Feb 12, 2011 | Cuisinart CJK-17BC Cordless Electric...

1 Answer

Water is leaking from the bottom


I was successful at fixing my Krups Electric Kettle for $4. In my case the water was leaking from bottom somewhere close to the heating area. I think that a small hole was created in the seal around the heating area in the bottom of the inside of the kettle. One can try to find the general location of the leak by putting a small amount of water in the kettle, place the kettle in a larger pan, and tilt the kettle so that the water is slightly higher than the heating area in one area only noting the position where the water level is above the heating area. Leave it for a while and check for leakage. If there is none, rotate the kettle a few degrees so that you have a new high point and look again for leakage from the new area until you find the area where it is leaking. Alternatively you may wish to put a sealant around the entire area, 360 degrees, around the top of the heating area. You mayl have to remove the strainer first to get your hand in the kettle to apply the sealant.

I went to my local hardware store and looked for sealants that were:
1. Potable (ie safe since you will be using the water for coffee, tea, and other applications that you ingest).
2. That will withstand heat up to at least 250 degrees Fahrenheit. Remember that water boils at 212 degrees.
I found epoxies that required mixing two compounds but decided that this would be difficult to deal with and apply. In the end I bought "PC Plumbing Epoxy Putty" from PC-Products. This met both requirements and was easy yo use. You take the putty and roll it between your finger just like you did in kindergarten with the clay and make a thin string that you could position in the crevice around the top of the heating area. You may either cover the area where you found the leak or the entire 360 degrees. You will note a somewhat foul smell of the putty. The manufacturers says that it will cure in 3 hours. I found that the smell went away when it completely dried and hardened after 3 weeks!.
I will assume that the same solution is applicable to leaks in other areas of the kettle. I have also found that there are equivalent electric kettles much cheaper than Krups. I would certainly check the construction to see if there is one with less of a chance to develop a leak.
But the bottom line is that it cost me $4. I just finished testing the Electric Kettle and it is fine, not leaking, and the instant coffee did not have any bad smell.

Meir Elazar

Feb 11, 2011 | Braun Kitchen Appliances - Others

3 Answers

The kettle leaks at where teh handle attaches at the bottom


Join the club ---I'm taking ours back this afternoon to BB&B. It's still under warranty and we have the receipt.

Nov 14, 2010 | Krups FLF2 Cordless Electric Kettle

1 Answer

Krups electric kettle keeps shutting off prematurely, from day one.... I lost my receipt


Buy a new one. Take the defective one, repack it in the old box and return it with the new receipt. Av a cup o tea.

Nov 11, 2010 | Krups FLF2 Cordless Electric Kettle

1 Answer

Krups Tea Kettle isn't working. I believe the problem is in the handle. It doesn't heat the water.


hello,

the handle has noting to do with the heater what you need to check on is the connection from the power supply if the connection is alright then you will have consider the element it is the heat provider connected to the wire it means that it is weak it need to be replace with a better one the element is in silver colour you can get it in any technical store/shop around you.

thank you

Jun 10, 2010 | Krups Stainless Steel Electric Kettle...

1 Answer

Power cord overheats


The thermostat is not shutting the unit down and cycling it on/off as it should. This will cause the power cord to overheat and it will catch fire. STOP using this unit and either replace it or have it repaired. More than likely cheaper to just replace it.

May 30, 2010 | Krups FLF2 Cordless Electric Kettle

2 Answers

Krups kettle leaks at base of pot


Unfortunately it's unfixable. A few recent Philips models do it as well and it's worst in hard water areas. Basically the cause is that a tiny bit of water gets into the bottom seam each time the kettle is used and leaves a residue behind when it dries out. Over time, the residue builds up and forces the seam apart so the leak gets worse.

All you can realistically do is hope that it's still under warranty and demand that Krups replace it, preferably with a different model. If they won't then you may have to exert whichever consumer rights exist in your country, but one way or another you need to stop using your kettle (it's dangerous!) and replace it with another.


May 21, 2010 | Krups FLF2 Cordless Electric Kettle

2 Answers

Krups electric kettle leaks


You cannot fix it when they split like that.

Apr 01, 2010 | Krups Stainless Steel Electric Kettle...

1 Answer

Krups kettle explosion???


go to krupsusa.com customer service

Oct 11, 2008 | Krups 848-70 \ 848-42 Aqua Control...

Not finding what you are looking for?
Krups FLF2 Cordless Electric Kettle Logo

Related Topics:

344 people viewed this question

Ask a Question

Usually answered in minutes!

Top Krups Kitchen Appliances - Others Experts

Mike

Level 3 Expert

4356 Answers

Oloyede Monsuru

Level 3 Expert

1417 Answers

Irene Tulloch

Level 2 Expert

484 Answers

Are you a Krups Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...