Converting kph to mph

under the console display there are small hole. Use the point of eraser pencil, make click, and ready. Of course another recently model you can do it by going to the MENU, and selecting kph to mph, read you owner manual if it is your option or download
www.fitness.manualsonline.com
God bless you

Use 2000W converter instead of 750W because you are using your treadmill on its full power on high speed. 750W converter is not capable of handling its full load resulting the machine malfunctioning. Your treadmill 785E have 2.25 CHP motor, 2.25 CHP is equal to 1677.824712W and 20-Amp minimum Ac outlet is required for your treadmill in order to function in full capacity. Download user's manual on: https://www.sportsmith.net/images/product_support/ProForm/PFTL785081%20-%20PROFORM%20I%20SERIES%20785%20E%20TREADMILL/PFTL78508.1-274823.pdf See Horse Power to Watts Converter on: http://www.rapidtables.com/convert/power/hp-to-watt.htm

Follow the next step:

• 1

Switchthe power off without unplugging the machine. Do not take the safety key out ofits place.

• 2

Inspectthe bottom of your console. The calibration switch is in a small hole. Insertthe eraser end of a pencil into the hole and softly push the button. You willsee CL11 on your console after you push this button.

• 3

Usethe Speed + or - key to select MPH or KPH. Push the Power key to save yourselection.
sincerely. God bless you.
E.CUADRA MANAGUA, NICARAGUA. C.A

Dear Sir:

Hello, I hope everything is fine.

I will help you inmediately.
Things You'll Need

• Pencil

1.

• 1

Switchthe power off without unplugging the machine. Do not take the safety key out ofits place.

• 2

Inspectthe bottom of your console. The calibration switch is in a small hole. Insertthe eraser end of a pencil into the hole and softly push the button. You willsee CL11 on your console after you push this button.

• 3

Usethe Speed + or - key to select MPH or KPH. Push the Power key to save yourselection.
Thank you in advance, sincerely. God bless you

If you need further assistance, please reach me.

E.CUADRA
MANAGUA, NICARAGUA. C.A.

1) adjust sensor reed switch or optical disk by 1/8" aprox and replace if neccesary after if the problem persist.
Chech the plug connector console panel vs. and controller board. If everything is wrong the console panel is bad.

I had this very same problem. I sorted it out this way: the information that Argos supplies says the speed starts at 0.8 kph with a top speed of 14 kph. If your Reebok Edge starts at a speed of 0.5 and has a top speed of 8.8, then the speed and distance is measured in mph, rather than kph. You can check this yourself with the following online speed converter:
http://www.eforecourt.com/mph_kph_speed_convert.htm

You need to go into the calibrate routine. If it doesn't cover it in your user manual, remove the motor cover and check for a spec sheet. The spec sheet will detail the entire calibration process, including changing kph to mph.

No need to take console apart, power up the treadmill, take the safety key out then hold down the start button and the incline down button at the same time then insert the safety key. You'll now be able to toggle between KPH and MPH by using start button

Treadmill is more than likely in metric. Most mill (if in english measurement) will start out at .5 metric usually star at .8 Not sure how to change for treadmill but it should be in the manual.