How do I get our sharp AR-M208N to work with windows 7?

try to go the site and you download www.sharp.com/support

Probably is a error referring to

Finisher Lift up trouble, on the sorter....

Tray that goes up and down, does NOT reach home position.

EEPROM read/write error (serial communication error)

reset u2
press c -interrupt-#-interrupt
press 16
press start
machine off
again machine on
remove this signal.

just remove the old one and insert new

Hello sir; This code require simulation to reset the procedure as follow; press "#", "interupt", "clear", "interupt", then enter 14 press start. turn power off and back on, then all set.

I buy and sell used copiers in southern California. That machine is pretty well aged and getting to the point where parts are not available. I would consider myself lucky to receive $400 for it.

Have you removed the seal from the toner before installing it in the machine? If so, make sure it's all removed. If that looks ok there may be a problem with your machine.

The 208 is a fairly new machine, you might still have warranty on it. I'd check with Sharp or with the company you bought it from for repair info.

On that page under Vista is a Post Script driver. You download by putting in PPD as your driver type.

It would be nice to have the PCL driver but the postscript should get you by unitl they release the rest of the software.

You have to use a Vista driver for that machine, check sharp's website and see if they have a driver specificcaly for Vista.