Question about Samsung PPM50H2 50 in. Plasma Television

Open Question

Samsung TV PPM50H2 50 power boost part???

I have a Samsung Plasma TV PPM50H2 50" I went to a repair shop and they told me it had a "Power Boost Problem" The TV just dont turn on when plug neither the fans on the back, just the led on the fron it turns green and then redn and you could hear a click un the back when powered.
I would like to kanow wath is the part that in need to be replaced and how much it cost, cause i think the repair shop is asking to much!!! Thanks

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


SOURCE: Plasma went black. Power not interrupted.

I can confirm Vladislav/ Jaime867's repair... Had the same problem on mine. Replaced the same two capacitors and bingo back in action.

I think the issue is that the capactitors sit between two heat sinks and if the display is flush mounted to the wall there is poor ventilation in there. I'm going to get a better mount and hopefully this doesn't happen again.

Cheers and thanks for the great fix!!! Only $4 bucks!


Posted on Jul 19, 2008

  • 1 Answer

SOURCE: Samsung LNR408DX/XAA Wont power up

    I followed the suggestion of checking the capacitors on the power board. They were shot so I tried taking the power board to get them replaced. It was really hard to get anyone to help me. Most of the repair shops stated they would not just fix the board and they would only repair it if the whole TV was brought in.     One of the smaller shops did help me out. He stated that this is not a Samsung problem, this is a LCD problem. My Samsung was only the second Samsung he has fixed in 4 months. He stated he has worked on many other brands daily with the same problem. This made me feel better after hearing all the problems and complaints on this thread.     The shop actually replaced all seven capacitors with 35v ones. He states blown capacitors won't be an issue in the future.  He explained that during some busy screen play, especially with HD gaming, these capacitors end up running 12-14v through them and that's what destroys the 10v capacitors. It's like putting a gallon and a half of water in a one gallon container and something has to give.     Sorry, I like to educate and explain things so am a little long winded. In Short: If you are experiencing clicking in your Samsung, Don't throw it out, Don't curse it, and call around to see who will not just replace the parts but potentially upgrade board to prevent future visits.

Posted on Aug 21, 2009

  • 101 Answers

SOURCE: my samsung plasma tv went out and it just makes a

It was not your power board, Thought the same on several repairs.Found out it was the main board. The clicking was the tuner relay. I bet you own a SP-R4232. If so,The part you need is BN41-00574A. Also might be under BN94-00669A. Hard to find. Try Shop Jimmy/Or Encompass Parts. Not cheep tho. Hope this info helps.
Have a happy new year. Todd

Posted on Jan 01, 2010

  • 1 Answer

SOURCE: Samsung TV won't turn on- trying to fix it. A challenging problem

People if you can fix your tvs thats great! However please understand there is a incredible amount of HIGH VOLTAGE running through any television and if you do not know what your doing it can be fatal. please be careful.

Posted on Mar 11, 2010

  • 1126 Answers

SOURCE: Samsung model HP-T5054 Plasma TV

When you remove the back of the set. You will fined a couple of caps on the power supply board that are bulged and they need to be replaced, or you can buy a new power supply at If you want to just purchase the caps, you can get them at

Posted on Oct 16, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I fix the problem with my TV? Details are below.

Normally on the Panasonic tv this will call for a service call. The key to getting it repaired correctly is to check for a certified Samsung repair shop because most of the parts come from Samsung. Now if you want to do your own research call to 800 number for Panasonic Tv see if there are any problems with that model that the manufacturer has extended but does not post. I had one repaired that the red light on also so I understand and it went out approximately 4 3/4 years. If your in the Atlanta area use Norman electronics they have repaired hundreds on tvs for me due to my work.

Mar 05, 2016 | Panasonic VIERA TC-P55ST30 55-Inch 1080p...

1 Answer

Tv programs freeze up numerous times during day. have to unplug, retart each time. what can be done? I HAVE VIP 222K MODEL.

There is an installation problem, and you need a technician. When the receiver reboots, it sends a boost of power to the LNBF until it gets a signal in return, or gets a response of no signal. If you have damaged lines, a damaged receiver, damaged LNBF, or low signal reception on your antenna, a rebooted receiver will, for a very short time, boost the signal enough to get reception. Then, the receiver will drop the power back to the correct levels, thereby eliminating the short term reception boost. A technician can repair your installation to improve the reception, as long as there is Line Of Sight to the correct satellites.

Oct 16, 2014 | DISH Network Televison & Video

1 Answer

When I turn on my Samsung galaxy prevail it shows the Boost page like when its booting up but the boost page is as much as far as it goes. I was told its missing the operating system for it. So how can I...

You are stuck in a boot hang up. You will need to lerfor. A factory reset. Here is how.
1. Power off M820 Prevail or take out battery and reinsert it.
2. Press and hold VOLUME UP and POWER ON your phone.
3. When you see Samsung logo release ONLY Power button but keep pressing Vol UP.
4. When you see recovery menu release VOL UP button.
5. Select Factory reset with Vol down and press camera key.

Dec 01, 2013 | Cell Phones

3 Answers

Hi iv got an nec 50 inch plasma tv model number pxt-50xd3 and i was told there is a power supply problem i was wondering if this is common and approximately how much will it cost me to fix?

Hi There I also have a nec 50inch plasma pxt-50xd3 its now not working. I have taking it to the repair shop who told me it was the power supply and it would cost me $550 to fix it.

Aug 30, 2010 | NEC PXT-50XD2 50 in. Plasma TV

2 Answers

My samsung plasma tv went out and it just makes a clicking noise and wont turn on i replaced the power board but it still does the same thing help anyone!

It was not your power board, Thought the same on several repairs.Found out it was the main board. The clicking was the tuner relay. I bet you own a SP-R4232. If so,The part you need is BN41-00574A. Also might be under BN94-00669A. Hard to find. Try Shop Jimmy/Or Encompass Parts. Not cheep tho. Hope this info helps.
Have a happy new year. Todd

Jan 01, 2010 | Samsung SP-R4232 42 in. Plasma HDTV

1 Answer

My mother purchased a new 20 in plasma. It is set

You need to go to service mode. Here how you go - use Samsung remote off the TV then press Mute-1-8-2-Power. Tv then boost up the service mode which is you could fine the line - user reset or hotel mode or both. You can press the user reset. If there is hotel mode - check it and put it OFF. Good luck

Aug 12, 2009 | Televison & Video

2 Answers

I have power, but no sound or picture

djchillsync is correct - the power supply on these are really poorly engineered and made. Audiovox is trying very hard to ruin thier reputation by putting ou **** like these sets. Contact them for warranty repairs, you may not get them paid for but you'll be directed to someone that knows what they are doing.

Jan 23, 2009 | Audiovox FPE3206 32 in. LCD Television

1 Answer

42" Sanyo HD Plasma TV (Model DP42746)

Not at all crazy! The Samsung/Akai lines seem to have numerous problems with their Y and Z sustain boards and upper/lower Y driver boards (aka buffers). That and power supplies are generally the largest percentage of the problems in those units. That said, I'm a bit confused looking at the p/n you referenced. I don't see that as being a Samsung number belonging to a Y-sus board. Usually they start with BPxx-xxxxxx..
Lastly, while you might have every ability to replace the Y-sus board if the buffers are bad and you don't replace them you could simply burn up the sustain board when you power it up... Installing the buffers is a bit more complex than the sustain board so be really careful there...\
Good Luck

Jun 05, 2008 | Televison & Video

3 Answers

Phillips 37FD9944/01S Plasma TV - Power Supply

dont waiste your money problem main or logic board or if shure power supply go radio shack and get one with specifications match voltage,ampers,and polarity

Mar 30, 2008 | Philips 60PP9352 60" Rear Projection...

1 Answer

RCA MM52110 tv

I had a repairman out to look at mine today. He said it was the high voltage protecter kicking off the TV as soon as you turned it on. $400 to $600. to repair.

I love this TV but guess I'll go shopping for another plasma. I have one Plasma TV in the bedroom 50" Samsung (top of the line) it doesn't have as good of a picture as my old RCA.

Jan 31, 2008 | RCA MM52110 52" Rear Projection HDTV-Ready...

Not finding what you are looking for?
Samsung PPM50H2 50 in. Plasma Television Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75756 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides