Question about Magic Chef CYE2000 Electric Commercial Dryer
The belt is likely broken. To be sure turn the dryer on and listen if you here the motor running the belt need to be replaced http://appliancehelponline.com/dryerbeltvideo.html If the motor is not running it could be a few other things and this link should help
Posted on Jul 13, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
turn on for a short time and listen for a low hum. if present, this means the motor is stalled. take of top and give the drum a push. if it then starts to run then the motor capacitor is faulty
Posted on Apr 27, 2007
The first thing to check is the drive belt. you will need to turn the dryer on its side and look to see if the drive belt is broken. If this is o.k it will be the motor.
Posted on Dec 08, 2008
SOURCE: dryer not heating up
Welcome to fixya.com
This sounds to me like the the timer switch is faulty and needs to be replaced.
Web site and schematics below. You can open them into the whole window and buy parts there too!
Thank you Huuum
Please leave a solved rating before you sign out
Posted on Jan 23, 2009
Heres what you'll need to do.
First pull out your lint trap and place your hand down in the lint trap hole not very far just enough to feel a good amount of air blowing on your hand. If you feel no breeze in there you need to clean the ducting, starting at the back of the dryer (where you hook it up at) and ending out side your house (where vents at). Snake it your self or have someone do it but just the same it has to be done.
Secondly you'll need to change you thermal fuse. If after snaking the dryer still doesn't heat. Changing the thermal fuse is easily done. Firstly you must unplug the dryer and then remove the cover off of the back of the dryer. Then you'll see the thermal fuse
(most of them look like this). Change it and put the dryer cover back on, plug it in and your ready to rock and roll.
Hope this helps
Posted on Apr 02, 2009
Tips for a great answer:
May 07, 2012 | GE Dryers
Jul 20, 2011 | Maytag Dryers
Dec 30, 2010 | Dryers
There can be many reasons why your dryer will not start or turn...
The most common causes are the belt breaking or jumping off, or the motor going bad...
Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...
Dryer Repair - The Dryer is not Turning
Dryer Repair - The dryer will not start
Dec 26, 2010 | Kenmore Dryers
Oct 25, 2010 | Dryers
May 20, 2010 | Maytag Neptune MDG5500AW Gas Dryer
Jul 07, 2009 | GE DVL223GB Gas Dryer
Apr 27, 2009 | Whirlpool LER4634J Electric Dryer
Jan 16, 2009 | Kenmore 62602 Electric Dryer
155 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: