Question about Kettler Mondeo Elliptical Trainer
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This is a common problem for the CTR1, it actually sounds a lot worse than it is. It's just one of the 4 bolts that hold the front "pole" of the CTR1 in place that is broken. You will need to unscrew the bolts at the base (just move the plastic piece that hides the bolts up on the "pole"). After removing the pole you will need to remove the broken bolt from the inside of the "pole" with plyers. Then just put the pole back in the base, replace the screws (be sure to tighten them good). All will be good :)
This is a weak point of the CTR1, be prepared to run into the same problem again down the road...
Posted on Jan 16, 2011
SOURCE: My Kettler cross trainer Mondeo
E-2 FAULTS ARE PROBABLY DUE TO A FAULTY CONNECTION BETWEEN THE CONNECTING PLUGS-MINE WAS,I CHANGED A LEAD IN THE END AND SOLVED THE PROBLEM.PLEASE SEE MY POST ON THIS SITE ON THIS MATTER. MARK DAVIES
Posted on Jul 19, 2011
Tips for a great answer:
Jul 31, 2016 | Kettler Fitness-Elliptical...
Apr 17, 2016 | Exercise & Fitness
Jun 28, 2015 | Kettler UNIX PX Elliptical Cross Trainer
Feb 24, 2015 | Kettler Verso 309 Elliptical Cross Trainer
Oct 28, 2014 | Exercise & Fitness
Apr 22, 2012 | Kettler Overstock Dual-action Cross...
May 22, 2011 | Kettler Mondeo Elliptical Trainer
Feb 10, 2009 | Kettler Exercise & Fitness
76 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: