My dish network remote is not working at all. It has new batteries but it somehow is not programeed with my reciever

Hey Brandon Kinsley,

It does sound like there is an interference issue with the remote control. Make sure there are no sources of heat or light near the receiver, and that it has a clear line of sight. Other possibilities for interference could be equipment or some LCD TV's have been known to cause interference.

If you continue experiencing any difficulties let me know here and I would be happy to try other steps with you, or see about getting the right remote out so you can make the TV1 a UHF signal to bypass that interference.

Tommy Faust
DISH Network

albertmjuras

Is this a new remote or the existing one? I have provided instructions on how to program the remote to your TV and to readdress the remote to your receiver. Select the model of the receiver you have, click on the link and the just follow the directions. The bottom portion of the page has links for TV codes to program the remote to your TV. If this doesn't work, you may need a new remote. I hope this helps.

Program remote to TV and receiver:
http://www.dishnetwork.com/SupportSection/remote-setup

Ray Calo
DISH Network

Hi pappy63my name is Mike Houston of DISH Network and there are some steps that will getyour DISH Network remote to change the satellite channels. The first thing youwill need to do is press the System Info button on the receiver or pull out thesmart card from the receiver, with the remote press and release the SAT buttonand press the Record button and you will see the number in the white boxchange. I will leave a link to help with these steps. http://www.dishnetwork.com/SupportSection/remote-setup

your dish reciever has different codes to work it see what the old codes were and set the new reciever to match

I had the same issue with the 55LD520 and my Dish 722 receiver.
Check out this link for some suggestions:
http://www.satelliteguys.us/dish-network-technical-discussions/193510-ir-remote-1-722-receiver.html

Putting black tape over the receiver IR sensor seems to be working for me.

probably not. you need the original dish network receiver remote. call your Dish provider for a replacement.

Hello my name is Michael Hurst with DISH Network. Sounds like your remote may need to be reprogrammed to the DISH receiver. You can press the Menu button on the receiver and that will get you to the System Info screen. Once you have this screen then press and hold Sat button until all the buttons on top of the remote flash red. Let go of the Sat button and pick a number between 1-15. Once the number is selected then press # and then Record. Watch the remote code number on the System Info screen. If this doesn't work then unplug the reciever from power outlet for 10 seconds and perform the step again.

I would be happy to help with that!

Whenever having a remote issue it's always best to post the model number of the remote in question, this can be found on the back of the remote. Usually issues with the remote are quickly fixed by readdressing it. Start by pressing the menu button, this can be found on the top left of the DISH Network remote, then press the numbers 6-1-3. We should not be on the system information screen, once there press the record button on the remote 3 times then use the remote to exit the menu.

If this doesn't fix the issue please visit: http://www.dishnetwork.com/SupportSection/remote-control for additional trouble shooting.

I had rca remote that did not recieve ir signals but rf signals instead. Check online with rca or in owners manual for what type of signal factory remote sends. The dvd player I had was 5 dvd and that was the case. Dish might have an option like direct tv where you can program rf signals as well. Call dish network support or look online

that maybe the case..you could put a shielded barrier(copper coated poly) between them.sounds like it's a little too sensitive