Question about Audiofonics ADF-242 Car Audio Amplifier

1 Answer

My amp my ADF-242 amp has parts burned out and need to be repaired

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 323 Answers

4 CHANNEL-1100w MAX
HIGH ENDURANCE SLIM AMPLIFIER
4 CHANNEL [2 OHM] 110W x 4
4 CHANNEL [4 OHM] 80W x 4
2 CHANNEL MONO [4 OHM] 220W x 2
2 OHM LOAD CAPACITY
VARIABLE LOW [40-250Hz] PASS FILTER
VARIABLE HIGH [40-250Hz] PASS FILTER
BASS BOOST
RCA PRE-AMP LINE OUT
SPEAKER LEVEL INPUT

http://www.bcae1.com/repairbasicsforbcae1/repairbasics.htm
This is a really good site to learn about repairing amps and anything else you want to know about car audio. Are you wanting to replace the board or looking for someone to repair your amp.?

Posted on Apr 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audio fonics amp ADF-2845


you dont have enough power for it. sell if for parts and buy a smaller amp and second battery.

Sep 20, 2013 | Audiofonics Car Amplifiers

1 Answer

I have a ADF-242 that is having sound output problems


If the car was running when testing sub and heard noise this could be engine noise and an inline filter would cure that problem and also have a good ground no more than 15 inches away from the amp.And good metal contact for ground.

Jun 06, 2010 | Audiofonics ADF-242 Car Audio Amplifier

2 Answers

Amp burned


You might be able to have it fixed. Some amp companies make their own parts, so you would have to sent it to them. If you can find someone to diagnose the problem first, you could save yourself some money. I have repaired amps with parts from Radio Shack myself.

Apr 07, 2010 | Rockford Fosgate Punch 401S Car Audio...

1 Answer

Audiofonics ADF-240 Car Audio Amp


Hi There buddy.

I have on many occasions had problems with the actual LP/HP/Full Range selector switched on the amplifiers.

Remember that the input signal runs through the switches before it gets to the main amplifiers.

Check that out and let me know.

Oct 30, 2009 | Audiofonics ADF-240 Car Audio Amplifier

1 Answer

Looking for audiofonics adf-240 owners manual.


There may be a loose wire to the lights, or the power supply or amp may have a problem. Do you have the amp mounted to your sub box directly? You shouldn't. The vibrations from the bub will kill the amp in a short amount of time. If it is noticeably weaker, you should check out all aspects of the system. For instance, if you have a dual voice coil sub, is one coil open? Is one channel on the amp bad? Is half of the power supply on the amp bad? hence half the power, and no lights?

Jun 11, 2009 | Audiofonics ADF-240 Car Audio Amplifier

1 Answer

Audiofonics adf-241 no power all wires connected fuses ok.


Hello pimprascalz,

Many amps will go into protect mode if one of the speaker wires is shorted or grounded, or if the voice coil(s) are defective. Try disconnecting the speaker wires one at a time and see if the amp still goes into protect upon power up. Likewise, some amps will go into protect if one of the inputs is grounding out. Again, to troubleshoot, disconnect them one at a time and try the amp. Next, make sure that the amp itself is not grounding. Most amps need to be mounted to a nonconductive surface. If the case contacts the frame of the vehicle, it can cause a problem. If the problem is not in the speaker wires or the input cables, the amp case is not contacting the vehicle frame, and you have checked your power, ground and turn-on leads, then the amp itself is probably faulty.

Hope this helps.

May 19, 2009 | Audiofonics ADF-241 Car Audio Amplifier

1 Answer

Boss C650 1000W amp melted fuses


CALL BOSE THEM SELF..OR A BOSE REPAIR SHOP THEY WILL GET THEM FOR YOU.......
THEN TAKE THE AMP APART DESOLDER THE HOLDERS AND REPLACE THEM YOU CAN GET A REAL CHEAP SOLDERING IRON AND SOLDER @ RADIO SHACK CALL A REPAIR PLACE.....FIX IT YOUR SELF SAVE YOUR SELF A LOT OF MONEY AS LONG YOU DID NOT BURN UP COMPONENTS TAKE A LOOK INSIDE FIRST BEFORE YOU BUY ANYTHING GOOD LUCK

Feb 04, 2009 | Power Acoustik LT-980/2 Car Audio...

1 Answer

My ADF-242 amp


it would be cheaper to buy a new one than to take in to a service tech

Apr 18, 2008 | Car Amplifiers

1 Answer

ADF-243 Amp


What you need to do, is also run the rca cable from the back of the deck to the amp. The speakers are already powered by the deck. You can then hook up your subwoofers. The switches are for your own taste.. you adjust them as you go.

Jan 30, 2008 | Audiofonics ADF-243 Car Audio Amplifier

1 Answer

Amp fan not working


If you have any experiance with electronics remove the casing and check the fan with a external 12V power source. If the fan still does not work, it needs to be replaced, try and get a brushless fan as it will last alot longer.

Mar 10, 2007 | Audiofonics ADF-242 Car Audio Amplifier

Not finding what you are looking for?
Audiofonics ADF-242 Car Audio Amplifier Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audiofonics Car Amplifiers Experts

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Pablo Gonzalez

Level 3 Expert

733 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you an Audiofonics Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...