Code error u2-91 error E511 - Epson Aculaser C1100 Printer

Part of the photoconductor unit known as the transfer belt is not being detected when the E511 Service Requested error comes up. Epson in the UK has the troubleshooting outlined here:

http://www.epson.co.uk/Store/Printers-and-All-in-Ones/Epson-Aculaser-C1100/Drivers-Support;jsessionid=035E9EA2127A8A5A478481112D9F98B2.acc2?target=article&extn=.html&articleId=1319

Error E511 is due to ur photoconductor.. the black transfer belt is out of position... it can be corrected if you know how to open up the photoconductor unit...

e511 is to do with the photoconductor unit which sits under the top lid

usually detector underneath the photoconductor dirty or the wide rubber belt then runs throuigh the photoconductor is sligthly off to one side

The "Service Req E511" error message means that part of the photoconductor unit called the transfer belt is not being detected. See the following Epson Article which may help. http://www.epson.co.uk/Store/Printers-and-All-in-Ones/Epson-Aculaser-C1100/Drivers-Support?target=article&extn=.html&articleId=1319

The "Service Req E511" error message means that part of the photoconductor unit called the transfer belt is not being detected. Please see the following Epson article which may help. http://www.epson.co.uk/Store/Printers-and-All-in-Ones/Epson-Aculaser-C1100/Drivers-Support?target=article&extn=.html&articleId=1319

The E511 error for your Epson Aculaser  in most cases means that its motor has malfunctioned or something is preventing the motor from working properly.

Hi-

Try reseating all the toners, as well as the photoconductor unit. If all fails do a reset using the panel. Call manufacturer for 562-276-4382 for step by step instruction.

Hope this helps

Hi,

To my knowledge Error Code E511 refers to photoconductor and/or its associated components. It is possible that:

• the photoconductor requires a bit of cleaning and to be reseated snugly;
• the black rubber conveyor (transfer) belt inside the photoconductor moved away from its path;
• the silver square reflector on the transfer belt needs cleaning;

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

E511 is in regard to the photoconductor unit. There may be the need to clean the black belt from dust accumulation (other users have reported success by that) whilst I had success by cleaning the surface of the optical sensor on the left, accessible after lifting out the photoconductor. Keep the photoconductor shielded from light while you do this. It usually about stray toner accumulated on surfaces within the printer. Be careful how you remove "dust", a vacumn cleaner can catch fire because the dust is susceptible to electrostatic charge build up.
Hope this helps.