The clips of my nintendo ds are broken. I need to get them fixed

If you want to buy a Nintendo screwdriver and work patiently, this is an easy fix.
One of your ribbon cables is being pulled out or is not connecting when you open your DS.
If you go to www.powergamingparts.com you can find manuals to assist you in opening the DS and where to locate the "clips" that you will need to tighten.
If you need any further assistance contact me.

Try contacting Nintendo Customer Service at http://www.nintendo.com/consumer/repair/ds_repair_home.jsp?region= or calling 1-800-255-3700 (Nintendo Customer Support).

the only way to fix it is either glue something in its place to hold it in, or buy a new stylus

donde puedo localizarlos para llevarles el nintendo ds

You need to buy a new DS. The cost of the screens and the time put into trying to fix it would be more than buying a new DS.

see if you need new carger or if it needs new batteries

were can i call to get information about my broken clip

need charger

I had the Same problem on my wifes DS.  First problem was that it kept swithing itself off, so sent it to Nintendo for repair.  Within a week it was broken again.

This time the green light was coming on, but no sound and no sign of life in the screens.

Well, I'd already had to pay nintendo for the first fix (different region, no warranty, apparrently).  So I thought seeing as it's out of warranty anyway, why not open it up and have a look.

To open it you need specailist tools, I don't recommend it if you've never done anything like it before.

Anyways, the bios chip was no longer connected to the main PCB.  I simply plugged it back in and added some slips of post it note to stop it coming off again.

You can see in the picture, the chip easily plugs back onto that white clip on the board.

Once it was back on. the DS has been working fine.

Hi, replacing the original nds upper screen is a fairly straight forward procedure, you need to remove the 4 x small plastic plugs located in the corners of upper screen, then remove the 4 x phillips screws, the top outer back part of the case will seperate and you can gain access to the screen. Firstly remove the small screw holding down the right hand pcboard to gain access to the ribbon connectors, release the larger flat connector by hinging the clip up, slide the ribbon out, underneath you will see a tiny connector, gently ease the small clip back towards the ribbon, prising a little each side at a time, remove the ribbon and then you can prise the screen from the case.
These guys sell the replacement screens www.ps2laser.co.uk prices are very competitive and offer next day delivery!