Question about Car Audio Receivers

2 Answers

NG Pajero radio cassette wiring

I am replacing the mitsubishi radio and cassette with a phillips radio cassette and have two extra wires on the pajero harness. one is green with white stripe (Earth I suspect) and the other is black with a red stripe. On the Phillips radio I have two wires left. One for earth and the other for a power antenna, which the pajero does not have. When I check with a multi meter on the live wire to the green/white wire, it reads 11.96V and with the live wire to the Black/red it reads 0.07V My question is this : is the green/white wire the earth and the black/red the power antenna?

Posted by on

  • luckidog May 01, 2009

    I have the same problem 1991 pajero gls can't get the antenna to work, to go up, can anyone help please

  • vzamindar May 26, 2009

    i have 1995 pajero,it has a cassette player,i am replacing it with a cd player but cant figure out the wiring behind the system as to fit the new system i have to cut the old socket and solder the wires into the new one.
    pls help ,my email is vzamindar@yahoo.co.in



×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What colours are the eart and negative wires on aclarion pu/2294aradio please

Posted on May 16, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The green/white wire is the earth - the earth to the chassis gave no resistance when tested with the multimeter to the car chassis. So it was a pretty good bet that the green/white wire was the earth as suspected. The radio cassette works a treat. Yipee!

Posted on Apr 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mitsubishi Eclipse Spider Gt-S I cannot figure out how to get the fascia panel and face plate off of the radio to get to the numbers needed to retrieve the radio code. How do I take the panels OFF?


Hi

The stereo in the Eclipse can be removed with nothing more than a Phillips screwdriver

Disconnect the negative battery cable from your Eclipse's battery. Remove the two Phillips screws along the bottom of the radio/climate control trim panel. Lift up the bottom of the trim panel to unlock the lower retaining clips. Work your fingers around the sides of the panel to loosen the other clips and remove the panel. Remove the four Phillips screws holding the stereo in place. Slide the stereo out of the dashboard and disconnect the wiring harness and antenna cable from the back of the device.

Also check this link if it helps:-

http://www.ehow.com/how_5938157_remove-eclipse-car-radio.html

May 04, 2011 | Mitsubishi Car Audio Receivers

1 Answer

How to integrate the pioneer deh-1300mp into a 96 Dodge 2500 Centurion diesel truck to replace a radio/cassette player.


The simplest way to swap the stock radio out for the cassette player would be to go to a radioshack or bestbuy, normally they will carry a double-din to single-din adapter so that the smaller after market radio fits into the existing location snugly. They usually also carry a wiring harness adapter that will plug right into your dodges existing harness and you can just wire nut or solder & shrink wrap the adapter to the pioneers harness, saves a lot of time and insures everything is where it needs to be.
Normally you can get both adapters for under $15, hope this is helps.

Mar 08, 2011 | Pioneer DEH-1300 CD Player

1 Answer

Hi I have just installed my now JVC KD-R616 and stumped on two issues, one is the orange wire with white stripe from the deck the install sheet says wire to car light control switch, what is its purpose?...


The orange light to the light control is usually for the face/display dimmer. When the headlights are on it tells the display to dim so as not to be too bright while driving. It can go to just about any interior light that is on when the headlights are switched on. Ashtray light is usually the easiest. As for the continuity on the constant/memory wire. It has to be constant with the key off as if connected directly to the battery. Turn the key off and check for a blank accessory location in the fuse box with a test light. If hooked to that, be sure to install an in line fuse in an accessible location. The black wire may very well be the memory wire from the original radio.
I hope I've helped. If so please rate my assistance and leave a testimonial.

Dec 30, 2010 | JVC AM FM CD DET FACE CAR STEREO

2 Answers

Will not hold its code


It sounds like the ignition live and the permanant live are wired in the opposite way round.you need to get the wiring checked out .

Mar 21, 2010 | Kenwood KRC-594 Cassette Player

2 Answers

Trying to install factory cd-cassette combo from a 1999 ford explorer into a 1996 ford crown victoria with only a cassette radio player. need to know wiring data on both vehicles.


Hi and welcome to FixYa,

On your need for the radio wiring of 99 Ford Explorer and a 96 Ford Crown Victoria, see below wiring scheme:

1752885.jpg

Confirm with a voltmeter on the +12 and an ohmmeter for speaker continuity.

Good luck and thank you for asking FixYa.

Oct 30, 2009 | Car Audio Receivers

1 Answer

I have a 2001 Dodge Ram 1500 that I'm trying to up grade my radio form a A and fm cassette to a dual CD cassette . I need help with wiring because they are different colors.I have the new 16 pin harness...


2001 Dodge Ram 1500 Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Red
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Black/Dark Green
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: Orange/White
Car Stereo Antenna Trigger Wire: Yellow
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

Sep 09, 2009 | Durabrand Car CD Player and AM/FM...

1 Answer

I don't know how to connect the wires from my JVC car stereo


Radio wire colors:
P o w e r Memory (+12v Constant) Yellow Ignition (+12v Switched) Red Ground (-) Black Dimmer Pink/White (Alpine only) Power Antenna Blue Amplifier Turn-on Blue/White Phone Mute Light Blue (Sony only) S p e a k e r s Right Front (+) Gray Right Front (-) Gray/Black Left Front (+) White Left Front (-) White/Black Right Rear (+) Violet Right Rear (-) Violet/Black Left Rear (+) Green Left Rear (-) Green/Black

1991 Oldsmobile Cutlass Supreme Car Stereo Wire Diagram
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger Wire: Pink
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 4′
Car Audio Front Speakers Location: Dash
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: 6′ x 9′
Car Audio Rear Speakers Location: Rear Deck
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
window.google_render_ad();

Jun 03, 2009 | JVC KW-XC777 CD / Cassette Player

1 Answer

My cassette player will not play the radio...


it sound like you fried the radio by taking the fuse out of the system that fuse was blowing for a reason power wire maybe grounding somewher check the power wire with a meter good luck.

Jan 05, 2009 | Blaupunkt Hollywood C30

1 Answer

Pre setting the radio station on the keh-p2800 cassette player


HAS TO BE A CONSTANT POWER WIRE THAT CONTROLS CLOCK AND SETTINGS SHOULD BE A 16-14 GUAGE WIRE THE SAY 12+ AND HAS TO BE HOOKED INTO A CURCUIT HAS IS POWERED ALL THE TIME (NOT ONLY WHEN IGNITION IS TURNED ON)

Jul 12, 2008 | Pioneer KEH-P2800 Cassette Player

1 Answer

Tappet settings on a pajero


hi ian this is a electronics repair forum so i doubt you will find anybody to help you with deisel tappet settings unfortulately.. have you tried a google search?

Aug 29, 2007 | Car Audio Receivers

Not finding what you are looking for?
Car Audio Receivers Logo

Related Topics:

781 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio Receivers Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...