Question about RCA D52W20 52" Rear Projection HDTV-Ready Television

1 Answer

RCA 55" HDTV

TV on and while watching "signal no found" appeared then a loud bang (sounded like a shot gun) sounded and the TV went out.  Turning the TV on, the light flashes and makes a buzzing sound.  Anyone have any idea what may have blown in this 2-3 years young TV?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • RCA Master
  • 1,635 Answers

Sometimes a part can go shorted, and an over voltage occures somewheres thus causing another part to blow. This can be anywhere from in the power supply to any of the other boards.

The set would have to be serviced to determine the cause and what was damaged. Most likely there will be the need to change some boards. Most of the service is done by a combination of board replacement and some component replacement depending on the exact type of fault.


Jerry G.

Posted on Apr 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a RCA D52W20 in. Rear Projection HDTV. Just a few minutes ago there was a loud pop while watching tv and then the picture when black. I immediately turned off the television, checked behind it, and...


This TV if the model # is D52W20 ,`Then it is Projection and has 3 Tubes Red / Green / Blue
these tubes Cost over $450.00 each problem will be in the Deflection Board/ it will be the bottom left hand side board that has the FBT flyback Transfomer on it.
Most common repair is 3 capaciotrs on the deflection board CP150 2200uf 16v use 25v, CP114,CP120 220uf 35v replace all 3 caps.

Dec 15, 2010 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Sony rear proj; kdf 55


If there is no picture but sound is audible then replacing the projection lamp will do otherwise, the TV requires to be diagnosed for any other hardware damages.

Aug 27, 2009 | Sony Grand WEGA KDF-55WF655 36" Rear...

2 Answers

Heard a loud


Sounds like it could be your power supply board. Same kind of issue i had. Try unplugging your tv completely for an hour.

Apr 15, 2009 | RCA HD50LPW175 50" HDTV

1 Answer

Sound went out on my RCA D52W20 rear projection HDTV while watching it.


ok sound on the rca itc222 chasis comes ofd one curcit board. This board is called the small signal board. but before we get this replaced we have to elemate a few things. one check you audio setings and make sure the amplifer is set to internal. also you speakers could have blown. and the connectors to speaker unlikely be loose. If these items are elemanted then the small signal board. a item that only technicians can replace. they have special computer interface they use to download data from the old to a new board when they replace it

Dec 10, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

No Picutre


someone shot your tv.





no really, I am just a smart a$$ --- but the loud pop sounds like it may have been one of the capacitors in the power supply board. check for a POPPED cap (rare) and if there is one, test the components in the related circuit - as SOMETHING had to happen to make a cap fail like that - maybe a voltage regulator? give it a look..

Jul 25, 2008 | Sony KP-48S35 48" Rear Projection...

1 Answer

Hitachi ultravision 50v500


there should be 3 sets of video rca jacks on tv or receiver they might have put them on the wrong rca jack in which they just need to be moved over
usually the 3rd set of rca jacks are component jacks not for tv or video but for low output signals say like cameras and only one set of rca's can be used at a time svg on one of them rca's will over power the vid's. so have no picture

Apr 14, 2008 | Hitachi UltraVision CineForm 55VG825 55"...

2 Answers

Rca hdtv m50wh754s


You need a audio cable for sound. HDMI cable is only for picture. I use the comp 1 plugs myself, better picture. I found with my TV that the HDMI cable is only good if you have a digital box for it. You can also use the plug to hook your computer to off your graphics card and watch downloaded movies on.

Oct 06, 2007 | RCA HD52W56 52" Rear Projection HDTV

2 Answers

Tv wont turn on


The loud pop was a capacitor blowing up or the high voltage transformer blew up. Very common problem.. if its the Transformer be expected to pay 250 or more to have repaired.

Aug 21, 2006 | RCA HD52W56 52" Rear Projection HDTV

Not finding what you are looking for?
RCA D52W20 52" Rear Projection HDTV-Ready Television Logo

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...