Just installed a new Blanco Torino, model 157183, and inadvertantly got saw dust in the waterline during installation. It is restricting the pressure on the faucet. What is best way to clean it out?

Ice maker will call for water 12-14 hours after plug in. If the ref was running and then Waterline was connected it should call for water in 4 hours or less. Easy rule, after 24 hours, ice bin should be full.

Check the hose connections at the spray head nozzle it sounds like it is leaking there and running down the hose and ending up under the sink.

I have found through experience that most of the time when water flow is reduced out of the spicket that the spicket screen is plugged up. Try to unscrew the spicket nozel tip and the screen should be inside of it. Look and see if there is something plugging it. If not vissible, clean the screen by running fluid through it backwards.

all the manual says is to insert the elbow onto the tube coming from motor and then install bag onto the elbow and for maximum performance empty the bag before it gets half full. On most table saws that I work on there is no fan or anything like that to force the dust away from unit, the best way is to run a shop vac and connect to the elbow for mazimum dust removal.

Water is the issue.
Replace the water supply valve under the sink and water supply line to dishwasher.
Over time as you can see minerals deposit in the valve and restrict the water flow to the dishwasher.
This is especially inportant on todays water saving units.
Many people replace an old dishwasher and hate the new unit due to a white film left on dishes.

Although you may have paid for a professional installation a new shut off valve is almost never replaced even though the waterline may have been at an additional cost to you..

Replace the water supply valve under the sink and water supply line to dishwasher. (See attached picture)
Over time minerals deposit in the valve and restrict the water flow to the dishwasher.
This is especially inportant on todays water saving units.
Many people replace an old dishwasher and hate the new unit due to a white film left on dishes.

Although you may have paid for a professional installation a new shut off valve is almost never replaced even though the waterline may have been at an additional cost to you..

Hi
Take the faulty element to a hardware or appliance store and buy a replacement. Install the new element in the stove. For a plug-in element, just plug it into the receptacle. For a direct-wired element, screw the new element to its wiring, reassemble the two halves of the porcelain insulator, and snap the clips in place. Test the element to make sure it's operating.
Thanks for contacting fixya.com

water valve is turned off, or waterline is blocked unit may have a screen or filter which can become blocked. remove waterline where it connects to unit,turn on water to check water flow at this point.no water, check line backward from this point to find pressure loss.if pressure is at unit connection procede checking forward for restriction . test machine.

just remove the filter, it will work properly