Need manual for LG RC797T - LG RC797T

Contact the nearest authorised service center for LG to get its original power regualtor card.

Yes, you can connect another VCR to the LG's video & audio input jacks and record from the external VCR. You may have to select the line input from the menu to activate these inputs.

I'm assuming you are referring to using the dish network remote to control your DVD/VCR unit. Use the instructions in your Dish Network manual, mine is on page 61, "Setting up using device code tables". Refer to the table of device codes in the back of the dish manual, pg 119, to look up your manufacturer. I used the DVD codes for LG as LG wasn't listed on DVD/VCR combo codes. Try each one until one works. I have the LG RC797T and the third code worked 824. Good luck!

I had the same problem. Took it to a shop. They said the control chip under the DVD player was defective. It would cost more to fix than it was worth.
I think the design is defective. The DVD player probably gets too hot a the IC dies.

im sorry i dont have a solution to this problem, but i tried the exact same thing and got that 0xE0 key problem, so my dad and i decided to unplug the unit and plug it back in and now the unit will not respond to the remote. did you have this problem at all? and what did you do to exit the setup screen?

Why can't I hear any sound during VCR or TV tuner usage? <--- click here and read the solution to this common problem

[email protected]

This sounds most likely like a bad mech assy (bad laser) only drawback is that LG does not sell just the laser but the entire mech as a whole (laser motor and case) which I belive runs around 140 to 160 from Andrews electronics

Factory Set
You can reset the Recorder to its original factory
settings.

1. Select the [Factory Set] option.
2. Press B to select [SET] then press ENTER.
3. Select [OK] and press ENTER.

Or you can see the manual on page 21 on Factory reset. here's the link:

http://us.lge.com/download/product/file/1000002451/RC797T.pdf

re setting the channel set up has worked with my machine. just have the recorder search for all channels. go to menu and set up.....

is there anything i can just take out?