Mfc 655cw shows paper jam but tere is no paper jammed anywhere

You press Menu/Set 2,0,3, then press up/down arrows set faxibility to on. Press menu/Set, then press up/down arrows to turn call waiting on or off. Press Menu/Set and lastly press Exit/Stop.

I had problem with Brother MFC-J6710DW complaining about paper jam. Went through whole paper jam procedure a few times with no avail and no visible paper jam anywhere. Found (googled) this to be a common problem for this device. Turn off / on didn't help either.
Finally ... I followed procedure to the letter, bowed possible dust away and ... pushed tray 1 all the way in. (It turned out it was not all the way in when I first started troubleshooting, and was pushed to the same inadequate position subsequently.)
This MFC is low-cost. Meaning it has few sensors, and subsequently is not very precise reporting errors.
Remember: "paper jam" alert may mean something not on exact place it should be, with this otherwise (so far) good value for money MFC.

Hi
Turn it off and on.
Try disconnecting the printer from power and from the PC.
Leave it as such for a while before connecting again.

Nothing to do, just shut off the printer and wait for 5 min. Then remove the tray and adjust the tray according to paper size and then try to print.

We have solved the problem by googling and get it free.
Thanks all the same.
Alan

look for a paper jam in the front and the back of the printer. open the compartments and take a look. if all is clear unplug the printer and then plug it back in. this will reset it. good luck.

yyyy

Ther is some tiny little paper piece left in the machine! You will find it at the left hand side near the gear wheels ;-)

It is possible that a small piece of paper is stuck in the paper path above the primary feed roller. It will most likely need to be disassembled.

Same problem here. I'm googling around looking for ideas.