Question about Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Error code F09/Whirlpool Duet front loading washer

Periodically I am getting an F09 fault code in the middle of a wash cycle. I don't know the model number of the washer but It was the only duet machine available at the time I purchased the machine. The washer is 5 years old.

Posted by on

  • 3 more comments 
  • Anonymous Jun 20, 2008

    F05

  • jtapscot Sep 29, 2008

    I have the exact same problem. Already checked the filter. Repair man cam out and changed out the pump motor. Still the same problem. How do you check the pressure switch?

  • Jim Grigus Jul 30, 2012

    I had the same problem, "F09", coming up on the panel that would shut down the washer. The solution given by Jeff was "spot on". All I had to do was clean out the pump filter as he recommended. In the filter I found a paper clip, two small safety pins and a couple straight pins. The steel in these objects was rusting and started to clog the holes in the filter. All I had to do is "Scotch Bright" the iron oxide stains off the filter and the inside of the filter. The washer is working great now, (New baby in the house, so it's getting a workout).

  • Anonymous Mar 22, 2014

    FALUT CODES E01,F09, ON WHIRLPOOL DUET WASHER

  • Anonymous Mar 31, 2014

    service code f12 on washer I have pressed reset code as instructed but still not working

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,911 Answers

"F09" is an Overflow Condition error. This is usually attributed to a malfunctioning pressure switch, loose or broken connector between the Pressure Switch, Drain Pump and Central Control Unit (CCU), or...a drain pump or drain line that has become clogged.

Since this problem occurs periodically during the wash cycle, I would check your drain pump filter for obstructions first. It could be that you have debris lodged in the pump causing it not to drain properly. To access the pump:

1. Unplug the washer.
2. Remove the lower kick panel under the door by removing the screws under the bottom edge. HINT: Placing a couple of blocks of wood under the front feet of the washer will make access much easier.
3. The drain pump is located under the wash tub in the center. HINT: If you own a shop vac, remove the drain line from the standpipe at the wall and pull a vacuum through the drain line. This will remove all residual water from the washer and make clean up later a lot less messy. Now, remove the cover on the drain pump and remove. Clean out the pump filter and check the pump impeller for obstructions.

If you do not own a shop vac, place a bunch of towels around the drain pump BEFORE you open it. There's about a gallon or so of water in the tub, drain line and pump.

Try this first, and let me know if this corrects your problem. If not, you may need to check the pressure switch and wiring. I hope this helps you.

Posted on Apr 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does it beep through the entire. Wash cycle. No code showing.


Whirlpool Duet GHW9150P Front Load Washer Beeping ...

www.fixya.com > ... > Whirlpool Duet GHW9150P Front Load Washer
Question about Whirlpool duet Washing Machines ... my front loader is not workingwhirlpool washer flashes and beeps will not finish a cycle 1 Beep/E10--Error: Water... It beeps through the wash and rinse cycle every couple of minutes. ... Cycle signal which tells you that the cycle is complete beeps through the entire cycle.

[PDF]front-loading automatic washer use and care ... - Whirlpool

www.whirlpool.com/.../U...

Translate this page Whirlpool Home AppliancesWash. This is the main portion of the wash cycle. You will see the washer tumble the load. ... Spin cycle. If the laundry is still wet, take half of the load out of the washer and try again. .... Using recommended AFFRESH® washer cleaner, add.

[PDF]DISHWASHER USER INSTRUCTIONS - Whirlpool

https://www.whirlpool.co...

Translate this page Whirlpool Home AppliancesThe first cycle using the sensor will run longer to calibrate the optical sensor. Rinse Aid. Using rinse aid will optimize your drying and wash performance. This dishwasher is ...... laundry detergent, hand soap, or dish detergent for hand washing .... models) you will experience more starts and stops throughout the entire cycle.

Continuous Beeping - Whirlpool Duet Sport Washer - The ...

appliantology.org > ... > The Laundry Appliance Repair Forum

Jan 25, 2016 | Whirlpool Washing Machines

1 Answer

Error code F09 for whirlpool


F09 Overflow condition If the Overflow contact on the pressure switch is Closed for more than 60 seconds an Overflow condition will occur. In an Overflow condition, the Door will remain locked, and the Drain Pump will run constantly, even if PAUSE/CANCEL is pressed twice and the Display is cleared. Unplug the unit to service.

Potential Causes

• Check the drain hose and make sure it is not plugged or kinked
• Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
• Check / Clean Drain Pump Filter of foreign objects
• Check for Drain Pump Failure
• Check the Inlet Valve for proper shut off
• Check the Pressure switch for proper operation

Replace failed component.

Read more: http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#Whirlpool Duet Front Loading Automatic Washer Fault Codes#ixzz2e96NFcLn
http://www.appliancepartspros.com

Sep 06, 2013 | Washing Machines

1 Answer

Whirlpool duet f09 error code


it is an overflow condition caused by either a plugged drain pump or a bad pressure switch,if you hit pause/cancel and the drain pump continues to run then check the drain pump cleanout for foreign objects

Aug 31, 2012 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

My front load washer had a f09 then e01 code come up today. I think something is clogging somewhere


blankets can be very heavy and ball up on one side of the washer during spin cycle and cause the washer to shut down do to inballance... remove blankets & spread them ou if the are twisted up also mabe leave one of them out and rinse separatly..

Jul 09, 2012 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

I have a duet front load whirlpool washer, I bought it about maybe 8-10 years ago. I'm start to get a error code when I wash on a 28 min cycle spin. The error is 5BR or 56R, it will stop spinning in the...


Hi these are not common codes for a duet. Click HERE for a list of common codes and corrective actions needed.

If you have any further questions please feel free to ask.

Nov 17, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

F35 code


Hi,
The following list of codes indicates an electronics communication problem with the washer:

Duet HT® washer - F01, F03, F06, F11, F23, F24, F27, F28, F29, F30, F31, F32, F35, F42, F61, F62, F63, F64, F65, F70, F71, and F99
Duet® washer - F05, F07, F09, F10, F11, F13, F14, F15, F21, F22, and FdU
Duet SportTM washer - F01, F11, F23, F24, F27, F28, F29, F30, F31, and F33

To remove the error display, press Pause/Cancel twice.

If Pause/Cancel does not work:
  1. Unplug washer or disconnect power for one minute.
  2. Plug in washer or reconnect power.
  3. Re-select the cycle and press Start.
NOTE: If the error remains on the display, call for service.

Take care

Jun 15, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

On whirlpool duet ,am getting fault code f21 in wash cycle.


Foreign objects in the prepump
remove access panel in front remove round plastic plug clear objects have towels ready

Jan 12, 2009 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Whirlpool Duet Front loader


"F02" is a Long Drain error and "F09" is an Overflow Condition. The following two links explain both errors:

http://www.fixya.com/support/r615268-f02_error_code_whirlpool_duet_kenmore

http://www.fixya.com/support/r805532-f09_error_whirlpool_duet_kenmore_elite

The common factor with both links is the drain pump. There's a good possibility that you have something lodged in the pump. The next link explains how to check the pump for obstructions:

http://www.fixya.com/support/r385845-checking_drain_pump_in_whirlpool_duet

Follow the links and check the items common to both, as this could be the source of the two error codes occurring. It does not take much to damage the drain pumps in these washers. If you do find something in the pump, clean it thoroughly, and it still does not work, you will have to replace it. Let me know if it comes to this point and I can give you advice on how to order a replacement and how to replace it. I hope this helps you.

Aug 27, 2008 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

F09 error code for whirlpool Model GHW9250MT


Please click on the following link for an explanation of the "F09" error code:

http://www.fixya.com/support/r805532-f09_error_whirlpool_duet_kenmore_elite

Read through the information thoroughly and let me know if you have any questions, or require further assistance. I hope this helps you.

Jul 19, 2008 | Whirlpool Duet GHW9150P Front Load Washer

Not finding what you are looking for?
Whirlpool Duet GHW9150P Front Load Washer Logo

13,738 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...