I have been quoted $600 for the top cover and sensors and $300 to install, do you have parts? Have you seen this problem? Is it a wide spread problem or does it just show up on older high page count 7300s? Thanks Craig Art Academy of Cincinnati
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Found old post for diffrent printer see if this info helps. Drums may worj the same even though diffrent models.
Problem with the Xerox Printers
Xerox XD130DF J2 error replace By lgrey on Jun 20, 2008 Xerox XD130DF J2 error replace drum
Best Solution posted 3 years ago
Rating:80%, 98 Votes
Im presuming that your have replaced the drum??
if so : Remove the new drum. On the front of that drum, there is a green cover. Take it off and what has happened is the flag on the gear had dropped in shipping. You will see a flag like piece of plastic on one of the gears, reset it to up and somewhat to the right. Then put the green cover back on That flag has to be in the up position when new. It passes down and actuates a drum reset switch on the machine. When that is back in the up position. re insert the drum and on the first revolution it will turn on the switch.
I think you might have a Spring missing for the Waste Toner Full Sensor. The machine tolerates the sensor status for 2K pages and then shuts it down.
Truthfully, it is really hard to describe in a few sentences. It belongs in the frame wall under near where you have the white waste toner section of the Transfer Belt. This spring pushes a flag up that hits the Paper Entrance Sensor (yes, near the bypass tray)
There is a firmware issue that causes that problem.
You can download it from the Xerox.com site and upgrade your machine. The instructions on doing that upgrade are also on the site.
Go to Xerox.com. Then click Suport and Drivers, then enter 7300, then to drivers and downloads and scroll down to the firmware update.
The problem is with the top cover assembly. It could be a few things. I would first try the toner sensor flags(the magnet may not be strong enough to read properly). Also replace the toner cartidge because it's magnet may also have gotten weak. Third, I would try the Toner sensor board.
I have had this problem with many printers and normally it is just the flags because of the weak magnets.
9-667 VH/VM Out Of Range RAP
The selected LD value was out of range.
·Refer to BSD 9.1 and BSD 9.15 for the following procedure.
·Clean the ESV Sensor.
· Check that the P/J141 on the ESV Sensor, and PJ 422A on the IOT Drive PWB are firmly connected.
Perform the following in the order listed.
·Go to the IQ 38 Charge Corotron HVPS RAP and check the Charge Corotron HVPS for proper operation.
·Ensure that the Charge Corotron Wire and Grid are in good condition.
·Go to FLAG 6 and FLAG 7 on BSD 9.1. Check the wires for an open circuit or a short circuit. If the wires are good, replace the ESV Sensor ( PL 5.1 ). If the problem continues, replace the IOT Drive PWB ( PL 9.2 ).