When i swich it on it says step off and press a... im not on it . i cant seem to get any further

make sure that no pending jobs exist in the que, Remove the device driver from Add / Remove program of the system and re-load the driver.

Here are some easy steps and codes that should help you out.



1. Hold down the clear TV button until all lights light up at the top of the remote
2. Punch in a 3 digit code (provided below)
3. Press the # (POUND) button
4. Try powering the tv on/off, and the volume. If one or more of these functions do not work, start over from step 1 with a different code

589

Becki Barned
DISH Network Customer Service

These are the steps on how to program your Universal Remote Control to your device even without the list of code.

1. Manually turn ON your device.
2. Press and "HOLD" CODE SEARCH
3. Press and release the device button you want to set up
4. Release CODE SEARCH.
5. Press OFF/ON repeatedly until the device turns off (you may have to press up to 100 times at a rate of once per second).
6. Once the device turns off, press and release ENTER.
7. With the device on, press any other button. If the device responds, no further programming is required. If the device does not respond, repeat steps 1-6.

It's a little button above your right knee. Try turning the ignition on (without starting it)... then press the button for about 5 secs... then start it. Should be out then.

use msn

RCA 000,006,011,019,027,034,038,044,046,088 <-----codes

Programming a Device using Code Search:

1. Manually turn ON your device (TV, VCR, Cable Box)
2. Press and "HOLD" CODE SEARCH
3. Press and release the device button you want to set up (TV, VCR, Cable Box) However, if you are using AUX for a device, press and release AUX first and then the device button for the type of device to be programmed (TV, VCR, or Cable). The selected device button will flash once.
4. Release CODE SEARCH.
5. Press OFF/ON repeatedly until the device turns off (you may have to press up to 100 times at a rate of once per second).
6. Once the device turns off, press and release ENTER.
7. With the device on, press any other button.

If the device responds, no further programming is required.

If the device does not respond, repeat steps 1-6.

hi just format your phone by step by step ok! 1St Swich of your mobile then Swich on Quick Ley Press Call Key(Green Key) * And 3 Number Ok !
Problem On Slove E-mail Me OK
My E-mail ID = [email protected]

Here's a step-by-step guide you can use.

This machine MIGHT NOT support vista!

If you run XP you should download the aggressive remover tool and delete all drivers. After restart of pc install mfl-pro suite and wait until software demands the connection to mfc.

Never connect machine to a hub!

It must be connected to pc usb!

*#7370# your phone will format