Question about Sharp Projection Televisions

1 Answer

I CAN'T GET MY AQUOS LC-52SE94U TO RECEIVE A DIGITAL READ ONLY AN ANALOG ONE AND THE PICTURE ISN'T AS SHARP AS IT SHOULD BY

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I called Sharp and they said that you cannot use a coaxial cable. You need to use either an S-Video or HDMI cable. That fixs not only the digital but also the mono audio issue (instead of stereo).

Posted on Jun 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am looking for base only for Sharp TV #LC65D93U. WHere I can find one?


Hello, the part # is CDAI-A368WJ01, and it's $233.00 everywhere I looked. If you will message me back on Tuesday, I'll see if I can locate a used on....tks

Sep 01, 2014 | Sharp LC-65D93U Refurbished AQUOS 1080p 65...

1 Answer

I have a RCA D52W20 rear projection HDTV. This TV was purchased in2005. I cancelled my cable and I just hooked up a digital antenna but the TV isn't finding any channels. What do I need to do? I was...


HDTV indicates the number of lines that are shown by the TV. (HD means that at least 720 lines can be displayed in a given picture.) To receive OTA signals, you need an ATSC tuner (digital) of sufficient power (with a clear path to the transmitter) these days. The RCA D52W20 was released in 2002 and only has an NTSC (analog tuner). You will need a digital-to-analog converter to receive OTA TV (unless any low power analog stations remain in your area).

Please note that the basic digital-to-analog converters that were available with the government coupon back in 2009 were SD (480i lines of pixels used) units. HD d-t-a converters exist but are more expensive.

I hope this helps.

Cindy Wells
(the phrase "digital antenna" is meaningless; check with tvfool.com or antennaweb.org for the direction of local transmitters. TVfool.com will give more information on the type of antenna (indoor, outdoor, amplifier) that you will need to receive channels in your area. Antennaweb assumes an external antenna but is very conservative in the stations that it will indicate that you can receive. Antennas are given a color rating based on how far away the transmitter can be to get a watchable signal. Since digital signals are either enough for the tuner to interpret or you get a "no signal" message, you often need a stronger signal than was needed to receive a watchable analog channel.)

Sep 27, 2011 | RCA Projection Televisions

1 Answer

How do I hook up a Sharp Bd-HP24Ua Aquos BD Player?


The only option you have is to connect it via Component cables (Red, Blue, Green) and analog audio cables (Red, White) to get an Analog HD 1080i at best picture and analog stereo sound. I have to tell you though, your BD player is better than your TV and by using it on this TV you are missing out on the unit's full potential of features. I would highly recommend you consider upgrading and if your're looking to save a few bucks and get an amazing picture, consider upgrading to a Mitsubishi DLP. They are as low as $799 for 60".

Apr 23, 2011 | Mitsubishi WS-65611 65" Rear Projection...

2 Answers

I have a Sharp Aquos LC-30HV4U which is supposedly HD ready. I am a Dish Network satellite subscriber. I do not know what to do to make this HD ready set receive HD signals.


Your reciver is already set for the hd. Alls satellite programing and cable already come in hd format. You can also get any info here.

http://www.dtv.gov/


Good luck and please rate FixYa!

Apr 07, 2009 | Projection Televisions

1 Answer

I have a sharp aquos LC-42D62U. It shuts it's self off and then after a few minutes it seems to reset it's self. You then can turn on the power button and it will turn back on. What is the problem? Thanks ...


is the picture and sound perfect while its on? how long ago did you buy it? under warrantee? if picture and sound is perfect while its on powersupply may be failing, i would get it in for service before something cooks itself.

Dec 13, 2008 | Sharp Projection Televisions

1 Answer

Sharp Aquos LC-20B6U-S TV NOW HAS NO SOUND OR PICTURE. IT APPEARS TO COME ON BUT WITH NO PICTURE OR SOUND.


This can be caused by many different things. Check power supply fuses. If ok suspect inverter board which drives screen. Check for bulging capacitors and open transformers or just find replacement cost using numbers on board. That may fixya.

May 29, 2008 | Sharp Projection Televisions

2 Answers

SHARP AQUOS LC-26P70E - Clock


Most TV's don't change with daylight savings time, since they do not operate with a date, just time. You will need to change it via the remote.
Good luck

Mar 30, 2008 | Projection Televisions

2 Answers

RCA P52939 - Can it receive HD-Only signal? Is it Analog-Only?


The P52939 RCA is a analog Standard TV you will need the Digital converter to receive digital signals

Feb 10, 2008 | RCA P52939 52" Rear Projection Television

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sharp Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...