Hello there. i have two lynksys WAG200G routers.

You can start here : http://homesupport.cisco.com/en-us/support/gateways/WAG200G OR http://compnetworking.about.com/od/routers/g/192_168_1_1_def.htm

try to access the Graphical Interface of your router.

1. Open your browser then type in on the address bar 192.168.1.1 then press Enter.

2. Type in the username and the password.

3. Check on the basic setup under basic setup there show be a dot on enable under Auto detect.

4. After putting a DOT click on save settings.


Hope this would help. Thanks.

go to this link and it should give a good guide line best of luck

http://lifehacker.com/#!5563196/turn-your-old-router-into-a-range+boosting-wi+fi-repeater

To extend the range using the wre54g, follow these guides.

Quick Guide

User Manual

Linksys RV042 is a great option for using two WAN connections (2 ISPs). It's also a reliable router with great features, but is as easy to setup as your WAG200G and other Linksys devices. They run about $150 though.

use the browser, type //192.168.1.x that is the ip address of the router, then you should be able to access the router using wireless capability. You can then make whatever changes you wish to make.

just reset it the router then again configure it then you get it

You need to go to the router's page. lynksys is //192.168.1.1 there you can set up you wireless encryption protocol (WEP) and name your broadcast SSID. The great thing about lynksys is you can have your wep key automatically assigned to you. Just make sure you use 128 bit encryption.

here is how you set up port forwarding:

1. log into the router;
2. Click the Applications & Gaming link near the top of the page. 3. You should now see a new menu. Click Single Port Forwarding or Port Range Forwarding.
4, Enter sth like: HTTP; 80; 80; TCP; 192.168.0.1; check
5. When you're finished, click Save Settings near the bottom of the screen to save your changes.

go to administration-> remote administration to set up remote management
Remember, remote Administrator requires you to forward the 4899 ports.

On the router's Setup Page / User Interface, adjust the MTU to 1400 and choose the option Keep Alive. That's under SETUP tab.