Question about HP iPAQ H2210 Pocket PC

1 Answer

Will not start up after recharging the battery

Tried pushing the reset button but nothing happen. will not power on reguardless..

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Hello :-) I think that your battery is causing the problem. You might have charged you ipaq to many times with a cheap battery and the battery might be completely dead. Or the battery might just be defective.

Posted on Jul 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Nothing happens when I push the power button on the front panel of NAD917 Preamp. Any idea why? Is there a way to reset the box?


Probably a fuse in the unit. Unplug it and open it. If you see a blown fuse, take it out and look at the writing on the metal part. buy a fuse with the same power ratings.
26159769-xw5r0njdk3z14arcwu30x1yh-5-0.jpg

Apr 11, 2016 | NAD Audio Players & Recorders

1 Answer

Will not power up


If you tried to reset it and nothing happened, the battery may be dead. This happened to my daughter's Garmin GPS twice. I replaced the battery and bingo! I never understand why the unity needs a battery even when connecting it to the car's power cord...

Mar 14, 2014 | Hipstreet Audio Players & Recorders

1 Answer

I can't turn my Kenmore upright freezer on.


Try disconnecting power for about 30 seconds, and then restore power. This will reboot the control and maybe restart.

Jul 09, 2017 | Kenmore Freezers

1 Answer

The dishwasher won't start, its stuck, pots/pan button is blinking, & the timer has (2)_ _ bars blinking. I tried to reset/pushed the start/resume button nothing happened. I pushed the cancel/drain...


did you hold the start/resume button for at least 3 seconds if this works the dishwasher will start ok but if there is a fault it will fail again best you contact your nearest service agent good luck

Apr 07, 2011 | Whirlpool GU2400XTP Built-in Dishwasher

1 Answer

81sv-300 Breaker was turned off then back on. 8 hrs later no hot water. breaker was found to have tripped. turned on but still no hot water. thermostats were found to have been at top:140,...


The button could be stuck on the thermostat or needs replacing. You try to reset it by putting the screw driver head against the reset button and bump the handle with your hand to try to free it up. I have tried that and it free up one, reguardless if it didn't you would have to replace it any way if it is bad.
The button should pree in to reset, also check element's out they can short and throw your breaker.

Jul 29, 2010 | Rheem 81VP6S/430126 Water Heater

1 Answer

OK.. I could not get a disk to eject from my wii console. I tried unplugging it and slapping it on the side.. I also found this site trying to figure out what i can do.. I took some of yalls advice on...


Oh my God ;-) Isn't it funny sometimes when you don't notice simple things, happens all the time.
I one time spent 30mins trying to turn on a PC, to only notice I was pressing the "reset" button and not the power button!
Glad I'm not alone.

Jan 03, 2010 | Nintendo Wii Console

2 Answers

I push the on button and nothing happens. is it


Hello,

Even though a lot of things might have gone wrong and caused this, especially if where you place the System is not well ventilated, and the CPU becomes very hot, it shuts down automatically...and you will have to wait for a few moments, get a cool environment and power it on. but I will also try and tell you some troubleshooting steps that you can try.

Since you have already checked the power source and all is Ok, then try this out:

Disconnect your PowerPack(Power Supply Unit) from the CPU and try to power your PC with another Power Pack (Power Supply Unit), that you are very sure is working.

If it powers up, then just get a new Power Pack(Power Supply Unit) for system.

If you cant do this yourself, just get a good technician to do it for you.

Try this first and let me know how it goes, so as to know the next step.

Hope this helps.
Goodluck!

Nov 21, 2009 | Hi-Pro (HP-P401W) (HPP401W) Power Supply

Not finding what you are looking for?
HP iPAQ H2210 Pocket PC Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18415 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

pontelemon
pontelemon

Level 3 Expert

538 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...