Question about Projection Televisions

1 Answer

Just got HD cable service and now the color on my samsung is way off.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Problem has been resolved. Thank you.

Posted on Apr 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Only reddish hue color for entire screen


In most cases these CRT projection sets made by Samsung for Akai are notorious for fouled cooling liquid in one or more of the CRT's. The CRT's in most cases are no longer available.

Aug 14, 2009 | Akai PT5598HD 55" Rear Projection...

2 Answers

Green tinted people


The only time I have had issues like this was because of the Component Cables not being in the right position (the Red and Blue connections switched), or a bad Component Cable where the Blue Connection is not receiving a signal. Swap out the cable to be sure and double check that it is properly installed. Green to Green, Red to Red , Blue to Blue.
Hope this helps,
skyassoc

Jul 18, 2009 | Samsung HLN5065W 50" Rear Projection...

1 Answer

Color fine with rca jacks but when using hdmi/component its not


There may be a number of problems that are causing your HD issues. They may exist in your TV, or in the box you use to tune your channels. Contact your cable or satellite provider and ask them to change out your box. If the condition still surfaces, then you need to have your TV checked. The component and HDMI jacks are both connected to the same electronics. This is why they are exhibiting the same problem.

Jul 15, 2009 | JVC AV-56P575 56" Rear Projection...

1 Answer

Adjusting color after color wheel replacement samsung dlp tv


There should be a jumper somewhere around the color wheel. I am having a problem with my color wheel, and after doing a lot of research I found that people that have the same problem as you changed the jumper setting. Try looking it up here on the net. Should solve your problem.

Mar 21, 2009 | Samsung HL-R4667W Rear Projection...

1 Answer

Samsung 52'' DLP rear projection -- green tint after moving unit


http://web1.toshiba.ca/support//ceg/techsupport/tsbs/viewtsb.asp?docid=TSB000064

Nov 16, 2008 | Samsung HLR5067WX 50" Rear Projection HDTV

1 Answer

Samsung 6768W DLP 2 yrs old Replaced lamp and now color is off Faces look like paint by number


possible solution:

http://www.avsforum.com/avs-vb/showthread.php?t=1050735

  1. You may need to adjust the index delay after the replacement. You will be able to tell because you may see strange color banding in any scenes that have colors close, but not quite the same, in tone. This is usually most obvious in face skin tones (i.e. “clay faces”). If you need to adjust index delay, turn off the set, wait for the lamp to cool down, then hit mute-1-8-2-power in succession. The set should turn on with the service menu popping up eventually on the left. I don’t remember which submenu “index delay” is under, but find it and usually it will need to be lowered. I believe mine started out in the mid-50’s and had to be lowered to 47. These numbers are different for each Samsung model, so just adjust until the picture is pleasing to your eye. By the way, the supposed “correct” way to do this is to make the reddish part of the test color bar appear the “most saturated”, if you have a color calibration device.

Oct 15, 2008 | Samsung HLR6768W 67" Rear Projection HDTV

1 Answer

I have a samsung sp42q2hl, which on the front of the tv say's it is a hdtv ready, and yet i cannot watch high defenition images or movies, also there is no hdmi inlet at the back so i'm not sure how you...


Hi.
Use component to connect this will give yu HD picture,
On the back of the set you will see A group of 5 phono sockets Blue, Green, Red, These carry picture,

Then Red, White, these carry stereo sound.
Component video 0831d.gif
Component-video cable b.gif
Component video improves the picture quality even more by not only separating the color from the black-and-white portions of the picture but by further splitting the color information into two color-difference signals. When the picture signal is split up in this way, you get an unfiltered, uninterrupted image, with better resolution and greatly improved color saturation. And this is why component video is the predominant method of hookup from HDTV set-top decoders to HDTVs.

So this is how your set can produce HD picture from Hd source.

http://dysonmanuals.llc.nu/

Jun 22, 2008 | Samsung Projection Televisions

1 Answer

Hdtv/ direct tv service


more then likely you are using component input if you are check to make shore they are hooked up correctly red to red green to green and blue to blue if they are you might have a bad cable I have not seen a color stream board bad yet

Oct 16, 2007 | Toshiba 50HX70 50" Rear Projection...

1 Answer

See lines in HD cable or DVD source images, also maybe a problem w/ color, see extra blue haze


It sounds like convergence problem to me. There are two ways to correct these concerns; Samsung does sell boards, so if you are handy you can replace the boards yourself. BUT I recommend calling a factory authorized service company. It isn't costly, the cost will run around $400 -$550.

Aug 14, 2007 | Samsung HCL4715W 47" Rear Projection...

1 Answer

Colors out of Whack on HD input 4 only


May need higher quality component HD cables? Tried switching Blue on Red? Just some thoughts.

May 02, 2007 | Philips 60PP9202 60" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...