Nothing happen when pressing the Start/Stop button.

Technics SL-QD33 doesn't turn - Vinyl Engine

www.vinylengine.com/turntable_forum/viewtopic.php?t=28381

Jun 3, 2010 - 15 posts - ‎3 authors
It powers up, lights come on but the platter won't spin. ... However when I press "start", nothing happens and the platter won't spin when ... the arm towards the record without pressing the "start" button. ... SL 7, SL-10... and / or any of the fully automatic Technics turntables using optical record detection......etc Marantz 6300 question...
15 posts
Nov 21, 2009
Dual CS505 turntable won't auto-start
13 posts
Aug 16, 2009
More results from www.vinylengine.com

Help!! My Turntable won't spin - AVS Forum ' Home Theater ...

www.avsforum.com/.../1316271-help-my-turntable-won-t-spin.html

18 posts - ‎7 authors

If when you press the start button the turntable starts but no heat then magnetron is faulty otherwise if nothing happens then the touchpad itself is faulty.

Try moving the tone arm lever to raise the arm, if it has one.(MAKE SURE YOU HAVE RELEASED THE ARM CLIP!) Then with the arm raised move the arm over towards the platter. If platter still doesn't rotate, and its a belt drive, A. The belt is bad. or B. The belt has come off the platter or motor pulley.

Hi!

Maybe this manual will help you: http://manualsbrain.com/ru/manuals/782782/?page=15
Here are described problems with Numark TT500 and solutions

Hello

Check whether the drive belt is in position. If it has slipped out of the motor pulley, turn table won't turn when you push start button. Mke sure that power chord is connected firmly and the power does comes to the player. If drive belt is deteriorated replace it.
There is no other special faults to occur to the player. You have the manual and refer to its fittings. OK.

hi,
from ur narration i think the ur turntables belt have some problem.it may be become loosend. if not put the belt correctly. first insert the belt on the round circle underside the plater( metal table). the put it on the turntable by pulling the belt with ur finger through the hole on the platter , engage the belt with the motor pully( brass spindle ). then plug it and try .
ok

May be there is a problem in the windows, but suppose it is not booting at all.

First Check once more your boot options from bios menu
Second If it still the same thing, extract your battery out of your laptop for 12 min, then try to power up your laptop pluging in your power cable(don't use your battery)
Third If it still not working, there must be a problem in your cooling fan, so check it, also check your motherboard & your graphics card (Most of this problems happens due to a problem in the computer cooling system in motherboard & graphics card)

Hope it works for you Christos

With the power cord getting hot it sounds like there is something up with the power supply section. Perhaps a faulty transformer or something.

HI. your control board has failed. you will need to replace the control board asap if possible.

did you ever open the turntable. It sounds like the on/off switch is bad. Remove the platter and screws with a phillips screw driver and just make sure the connections are in place. make sure you disconnect the power first. let me know what happens afterwards.