Ge profile convection oven giving error code F7. What parts do I need

Question edited for clarity and all the typos.

All questions need 'make model (what it is)' as first 3 words.

Generic advice on a generic F7 Oven Error code.

F7 error code can be a result of a faulty wire harness (short-circuit), defective heating elements or oven sensor. A qualified service technician will need to have a look, determine faulty part then replace or repair it.
Apr 27, 2023

Help library: Electric Range: "F-7" error code - troubleshooting

https://www.google.com/search?q=Oven+Error+Code+F7

..

U have a bad clock or your probe inside of oven is bad.I would replace your probe first .it looks like a rod sticking out inside back upper top .f7 I believe means its not reading up temp and getting to hot

F7 A = Function pad button stuck or
B = Bad clock Unstick button or
Replace Electronic Range Control (ERC)

Hello & Welcome to FixYa

F7 error code is displayed when the clock assembly/electronic range control (ERC) goes bad and needs replacement. Please get back to me if you have any other questions.

Kevin

Hello there
Any time that you get the f7 error this means
F7 Shorted Clear/Off Key due to membrane switch, control or connector Shorted key panel membrane switch; Check Electronic Range Control (ERC)
repair or replace keypad switxh or erc circuit

Hi
On a GE range oven F7 indicates either a function pad button is stuck or the clock on the oven is malfunctioning

On the 99 Range oven F7 indicates a shorted Clear/Off Key due to membrane switch or a shorted control or connector

On the GE XL44 Self Clean Oven F7 is Stuck keypad or control relay malfunction
check out more detail here
http://www.fixya.com/howto/h155060-dreaded_f7_error
hope this helps

f9 means your control panel needs to be replaced..chances are part is not covered and if it is the only way you can obtain it is through having service

F7 A = Function pad button stuck or
B = Bad clock Unstick button or
Replace Electronic Range Control (ERC)

Hi there,
Well, F7 error code occures due to
A = Function pad button stuck or 
B = Bad clock Unstick button or
Replace Electronic Range Control (ERC)

Replace the ERC there are ten screws 3 on each side and 4 on the control leave the hex screws alone all you need is a phillip screwdriver.
REMEMBER TO SHUT OFF THE POWER FIRST lift and fold out the control panel remove the ribbon cable and remove the four screws that hold the control board . replace control panel in reverse order.
Best of luck!!
Thanks

http://www.fixya.com/howto/h155060-dreaded_f7_error    Go to the above link.  I will fix it.