Question about Packard Bell (190169) Power Supply

1 Answer

Power cts off after a few sconds of starting - Packard Bell (190169) Power Supply

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,027 Answers

That indicates an overload condition.

Posted on Jun 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I accidentally pulled on the plug to the ECM on 04 Cadillac CTS while trying to jump start a buddy now the gas gauge reads empty was working fine till then, can I reset it?


Unless the ECM has been damaged, it should do a complete reset when power is removed and reconnected. Disconnect the negative lead on the battery, carefully check all the plugs on the ECM, wait a few minutes and then reattach the battery cable.

Jan 05, 2017 | 2004 Cadillac CTS Sedan

1 Answer

Car loses power for short time after normal running and cooling down for ten minutes


sounds to be symptomatic of a CTS (coolant temperature sensor). there are two, one is for the interior temp gauge, the other is for the ECU/PCM while both are basicalty the same part, often even the same P/N, they both do extremely different things.

Feb 24, 2014 | Ford Ka Cars & Trucks

1 Answer

I have a 2003 Cadillac cts and it cuts off suddenly while driving and when I try to start it wont until a few minutes later


change your crankshft sensor and camshaft sesor same problem with my moms caddilc cts(and one more thing open your gas cap listen for a hissing sound ..get another person too put the vehicle on on but do not start vehicle.....if there is a hissing soung fuel pump is good)

Jan 03, 2012 | 2003 Cadillac CTS

1 Answer

When i turn the key i just hear a click and then a few sconds later it will usually turn over. Sometimes i have to turn the key multiple times before jeep will start. click, a delay and then it starts.


You need to clean your battery cables.
Try vinegar and sandpaper to get a better contact.
Most jeeps need about 500 amps to start, a dirty cable will lower the amperage the cable can carry

Nov 25, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I have a 1200 watt G-Max sub amplifier and it just went into protect mode


Turn down the volume or power settings on it since its pulling too much power and shutting off for a few sconds to keep from blowing. Depending on the amp and speakers your using dont bridge the channels. If it won't come out of protect mode then unhook everything and just hook power, ground, and remote and wee what happens. If it comes on again and stays on then amp is blown.

Aug 11, 2010 | Jl Audio Car Audio & Video

1 Answer

I have a 2003 a Cadillac CTS my key is stuck in my ignition so my power to the car is still on and i can start the car i just cant get the ignition to cut the power and give me my key back


I had the same problem with my CTS. I took it to my car guy andhe could not get any codes, so he took it to a tranny guy and he had the same problem. I finally took it to the dealer,, and the Power Control Module was bad. It is under a recall for ten years 80,000 miles

Jun 13, 2009 | 2003 Cadillac CTS

1 Answer

04 cadillac cts changed power steering pump and now I have trouble steering when i start to turn


Take the cap off the power steering unit start car and slowly turn to right and left to bleed air out of system refill and put cap back on.

May 11, 2009 | 2004 Cadillac CTS

2 Answers

No sound no picture, the stand by light blinks four times


If you have the above model, then the four blinks indicate a backlight failure. The back light inverter board might be defective or the voltage from the power supply (+24v) is low or missing.
Let me know if you require further assistance.

Dec 30, 2008 | Sony BRAVIA KDL-40S2000 40 in. LCD HDTV

Not finding what you are looking for?
Packard Bell (190169) Power Supply Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Packard Bell Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18402 Answers

carey w mason
carey w mason

Level 2 Expert

43 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Are you a Packard Bell Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...