Question about Nordic Track NordicTrack Treadmill, A2550

Open Question

Norditrack A2250 panel not responding

I have a norditrack A2250 model NTL 77806.1, everytime i push any button on the panel it just beeps and nothing happens, i tried unplugging, plugging back in, pushing reset button, and Pressed the Stop and the Speed Up keys down while inserting the safety key, still nothing will operate?

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Belt in Norditrack C2000, seems to be slipping

It could be the drive belt but the walking belt also gets sloppy over time and needs to be tightened. There are usualy two adjustment scews and the end of the treadmill which move the rear roller forwards and backwards. A good rule of thumb is that the belt should be just tight enough that when you plant your foot down hard on the belt when moving (3mph) the belt will barely slip. Care must be taken to make sure the belt stays in the centre. I get the belt to a good tightness then put the treadmill on full speed and watch the belt for tracking, if it does track make very small adjustments to the rear screws and watch again, repeat this until the belt stays in the centre.

Posted on Jul 12, 2009

Robert Braun
  • 77 Answers

SOURCE: How do I lubicate my Norditrack T9ci?

You get a tube of lubricant and instructions in the kit at treadmill accessory kit.

Posted on May 30, 2010

  • 218 Answers

SOURCE: i have a norditrack exp 1000x, on the lower

The overlay is bad. You will need to replace the whole console because nordic track does not sell just the overlays. you can get the console at iconservice.com or check on ebay

Posted on Aug 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Norditrack E7 SV display malfunctioning.


The control panel is defective is the most likely cause.

Jan 18, 2017 | The Video Game Consoles & Games

1 Answer

Does this norditrack use wax or silicone lube


Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

I am assuming you have never waxed your machine before. If this is the case, you should be safe using the liquid silicone lube. When this becomes an issue is if you were using the powder wax and tried to change to a silicone liquid. It would still work, but you would, more than likely, end up with some wax build up on your rollers.

How to Lubricate Treadmill Using Liquid Lube Video

Jan 05, 2016 | Exercise & Fitness

1 Answer

Have a norditrack T7si that stop working in the panel but just half of it.. the other half buttons work good and the treadmill doesn't have any other issue. Help please!


More than likely the console needs to be replaced. There is not repair available, the entire console will have to be replaced.

Oct 27, 2015 | Exercise & Fitness

1 Answer

Ifit card reader on my norditrack C2255 dosn't work.


Sounds like card may have lost the data. This can happen if static discharge causes the card information to vanish.

Feb 26, 2014 | Exercise & Fitness

1 Answer

Nordictrac a2250 beeps when key is attached


adjust the reed switch first, and after RUN the software calibration for diagnose and troubleshooting. see the diagram

God bless you
6_20_2012_12_48_33_pm.gif6_20_2012_12_48_46_pm.gif

Jun 17, 2012 | Nordic Track NordicTrack Treadmill, A2550

1 Answer

I have a norditrack exp 1000x, on the lower part,of the control panel,the functions,have stopped working.but the upper function keys are ok.what do think is wrong.?


The overlay is bad. You will need to replace the whole console because nordic track does not sell just the overlays. you can get the console at iconservice.com or check on ebay

Aug 11, 2010 | Nordic Track Nordictrack Exp 1000...

1 Answer

How do I lubicate my Norditrack T9ci?


You get a tube of lubricant and instructions in the kit at treadmill accessory kit.

May 30, 2010 | Nordic Track NordicTrack T9 ci Treadmill

Not finding what you are looking for?
Nordic Track NordicTrack Treadmill, A2550 Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nordic Track Exercise & Fitness Experts

Matt Olenzek
Matt Olenzek

Level 2 Expert

293 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Paul Sikkema
Paul Sikkema

Level 2 Expert

171 Answers

Are you a Nordic Track Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...