Question about Hitachi 53FDX01B 53" Rear Projection Television

2 Answers

I have a Hitachi 43FDX01B. When I turn the tv on,

I have a Hitachi 43FDX01B. When I turn the tv on, I get no picture/static or sound. I can see the power button light come on, but nothing else comes on. I never had a problem before, but there was a storm the other night. I'm wondering if it is worth it to even try to see if it can be fixed. The tv is 10 years old. Thanks!

Posted by on

  • t4ericj Jun 10, 2010

    The tv still didn't work, but I appreciate the instructions on how to reset. I think I may just have to replace the tv.

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,619 Answers

Hi


Thanks for using FixYa. You’ll need to reset the Projection TV and to reset it follow these steps:

  1. Turn off the television and wait for 5 minutes.

2. After 5 minutes unplug the television power cord from the electrical outlet.


3. Let the television remain without power for more then 1 minute.


4. Plug the power cord back into the electrical outlet. If the television is plugged into a power surge protector, remove it from there and plug it directly into the wall outlet. Turn on the television. If the issue is resolved, then the problem is with the power surge protector and not the television.


If the issue is not resolved then this might have happened due to over-voltage. Please check the power supply unit for swollen/bulged capacitors and burnt wires/components on the power supply board of your TV. You should try and turn off the TV for 8-10 hours to reset it. Please make sure to turn off and unplug the TV for at least 1 hour (this will drain off current from all components especially capacitors) before you perform any repairs. Also note that the TV consists of very high voltages even when it is in OFF condition. All this is only recommended if you have electrical expertise and know how to solder/re-solder components. Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks

Rylee

Posted on Jun 04, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Tv does not go on the d931 diode is blinking

Posted on Jul 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Hitachi 43fdx01b has no picture it started to get dimmer and dimmer every day for about a week and then no picture just sound, Any help would be appreciated


Ur tv projection bulb that in ur tv right now?The bulb in the tv right now been in used for 1 1/2 or 2 years in use?The tv been watching like every day like 4 or 5 hours a day?The bulb life span is over,must change the bulb.

May 29, 2010 | Hitachi 43FDX01B TV

1 Answer

Hitachi projection model #43fdx01b.distorted color, blue off set. Half moon line at the top, taking top part of picture.


Ur convergence is dead.U need buy a convergence kit,U know how to solder right?Buy it at these websites.Tv Repair World.com or Ebay.com.

Sep 30, 2009 | Hitachi 43FDX01B TV

1 Answer

Tv's picture is messed up.


Symptom: Blue convergence off, bowed inward at the top and bottom with No blue vert movement.
Cause: Replace IK05 (STK392-110) and RK54 (1.5 ohm/1W) and converge. RK50(2.2 ohm/1W)

Sep 20, 2009 | Hitachi 43FDX01B TV

1 Answer

43fdx01b turns off in 20 sec


if you know how to used soldering iron, solder your tv specialy the power supply and the jungle IC becouse 50% of the tv problems is lose connection .

Jan 26, 2009 | Hitachi 43FDX01B TV

1 Answer

Hitachi 43FDX01B TV Problem


if you have chirping sound .. check your horizontal out transistor that may be one cause there are seven or nine green lights around power supply see if all came on if not call me 520-248-4242 or leave message

Apr 16, 2008 | Hitachi 43FDX01B TV

1 Answer

Hitachi 43fdx01b chasiss dp05f


some times convergence IC's coused to put set in shutdown unloading the three convergence connectors and trying to turn on the tv if the set turn on the problem is convergence IC's if not check voltage regulator ...if still having problems e-mail me

Mar 18, 2008 | Hitachi 43FDX01B TV

1 Answer

Hitachi ultrasound big screen


you may have sound bord problem try using the sound out put from RCA connections in the back if you have sound from that source check the menu find out if speakers are turn off if still have problems e-mail me

Mar 14, 2008 | Hitachi 43FDX01B TV

2 Answers

Hitachi 43FDX01B


You likely have a fuse bad on one of the supplies to the convergence output IC's.  check EP96 and EP97.

Sep 27, 2007 | Hitachi 43FDX01B TV

Not finding what you are looking for?
Hitachi 53FDX01B 53" Rear Projection Television Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

Jaime Hernandez

Level 3 Expert

2318 Answers

The Knight
The Knight

Level 3 Expert

74459 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...