Question about Dell 3110cn Laser Printer
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The following steps are the troubleshooting steps that should be followed for error code 010 397.
First, the definition of the failure is <IOT Fuser Failure>, and means a Fuser Error is detected.
1) With power off, reseat the fuser by physically removing it from the printer, then reinstalling it and locking it in place. Turn the power back on. ( if the error is still present, proceed to step 2 ).
2) If reseating the fuser did not resolve the problem, Replace the fuser with a known good fuser.
( if problem is not resolved, proceed to step 3)
3) Replace the LVPS ( low voltage power supply ). ( if problem not resolved, proceed to step 4 ).
4) Replace the PWBA MCU ( printed wiring board assembly - machine control unit ).
END of troubleshooting.........
In most cases, the fuser itself is the problem. If you tried to reseat or replace the fuser while power was still on, the LVPS could have been damaged just as if there were an electrical storm.
Hopefully this helped.
Posted on Oct 02, 2008
We had the same problem. I loosened the levers that hold the fuser in place, and the one on the left side (as you face the printer) came out. When I put it back in, it didn't click into place all the way and the error message came up. I pushed down slightly on the fuser, then pushed the lever toward the back of the unit about as hard as I dared until it clicked back into place. That locked the fuser into place properly and resolved the problem.
Posted on Oct 06, 2008
SOURCE: Dell 3110cn Error 024-695
Had the same problem and found the removable bottom 250 page feeder assembly to be the culprit. Sorry I did not trace the problem to a specific part on the assembly but was lucky enough to have a replacement unit.
Posted on Oct 30, 2008
SOURCE: Error 003-343 Dell 3110cn
Open the printer using the button on the side top right. You will see two gray things with arrows going left and right. move them both two where you can take out the piece it is hold in. Pull out the large piece and put it back in. Close the two gray things to lock it back into place. Close the printer and restart it. It should fix your issue. It must of became loose at one point when I was moving so I fiddled with it and turns out that was the issue. It works great now!!
Posted on Nov 09, 2008
click on the following link
download the maual and print it if yu want.
Posted on Dec 10, 2008
Tips for a great answer:
Feb 04, 2015 | Dell 3110cn 3115cn and 5110cn Color
Jun 13, 2011 | Dell 3110cn Laser Printer
Jan 22, 2010 | Dell 3110cn Laser Printer
Oct 26, 2009 | Dell 3110cn Laser Printer
May 08, 2009 | Dell 3110cn Laser Printer
116 people viewed this question
Usually answered in minutes!