Question about Audio Players & Recorders

1 Answer

I have a yamaha mg82cx mixer and my bar lights dont really light up

Posted by on

  • 1 more comment 
  • cazzaa Apr 09, 2008

    lol ok well my mixer is hooked to my pc through my sound card i was told the lcd lights are supposed to light up but even if i yelled in my dynamic mic i barely get the first line lighting up here are my settings..

    gain is at just over half compression is 3/4 green light bla dont matter i know how to muck with them the big white one under those is just over half my effects are on my phatom button is not pushed red knob under that? dunno monitor phones is just over half monitor mix is at half to stereo to monitor button is up and my stereo butoon the big red one is at 3/4 isnt the lights spose to flash up more? lol i dunno and ty

  • cazzaa Apr 09, 2008

    so yeah maybe it isnt getting enough level i dunno lol

  • cazzaa Apr 09, 2008

    ok thanks

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

Hehehe sounds like a good party... mixers... bar lights... balloons..lol can you describe to me again what is happening? Is it the master VU that is not coming up or not glowing brightly, or just not enough level coming through the mixer to light up the VU?

regards
Graeme

Posted on Apr 09, 2008

  • Graeme Ross
    Graeme Ross Apr 09, 2008

    OK, have you got an instruction manual for the Yamaha. If not you can get one from here

    It may be that you need to adjust the GAIN control.

    Page 6 of the manual has a quick guide to do what you need. Cam you follow the direction given there, and if you have any dramas, please get back to me here and we can talk it through.

    regards
    Graeme

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have no monitor signal


A little vague, there, Chuck...
We have no idea if you even know how to plug the thing in... an no, it's not obvious because some people don't. Describe your connections and a little more about the problem.

May 27, 2014 | Yamaha Mg82cx Stereo Mixer

1 Answer

When i record i can hear me very well but the beat has like a funny bass sound to it what can i do to stop it


If your mic can "hear" the beat, it will record it as well with a reverberation that will NOT be pleasing. Maybe you can use headphones to avoid that.

Jul 13, 2011 | Yamaha Mg82cx Stereo Mixer

1 Answer

Yamaha mg82cx locked up, all led's on, no audio signal


Check the power adapter. It is a 38 volt AC centertapped unit with 0.62 amp rating. Verify that you get 38 volts AC between two of the pins and 19 volts AC between any other pair of pins with an AC voltmeter.

Check that the connector is seated. These can sometimes seem to be seated but not fully in place.

Apr 24, 2010 | Yamaha Mg82cx Stereo Mixer

1 Answer

Hiss


If trim controls or gains are set near maximum, HISS is normal as electronics generates a thermal type noise.

If gains are set in normal operating area, the noise SHOULD be minimal.

Other sources of interference like nearby radio transmitters, welders, arc lights, etc. can create noise.

Start with ALL gains turned down and find which if any cause the noise to be unacceptable.

MAKE SURE all power to this and ALL the other connected equipment come from a single receptacle to avoid ground loops.

Jan 02, 2010 | Yamaha Mg82cx Stereo Mixer

1 Answer

Where can I purchase a European compatible power adapter for a Yamaha MG82CX mixer?


what is the voltage/current/wattage of the unit this info should be on the back/underside of the unit, Also what type of power supply plug does it take? Maplin electronics throughout the uk or any good electronics parts supplier should be able to help you? Have you tried ebay etc?

Jul 14, 2009 | Yamaha Mg82cx Stereo Mixer

1 Answer

Hooking up Electronic drum kit to mider


sorry ...you haven't enough channels to mix all the kit ... you will have to run a stereo pair from the td8 to mg82 and mix it from the td8

Feb 01, 2009 | Yamaha Mg82cx Stereo Mixer

1 Answer

Confuse about the jack


Both stereo and mono jacks will work fine on the inputs, any guitar or mic lead will work a treat.

You can use stereo jacks for the outputs too, but to keep it simple just use a mono jack in the L out and a mono jack in the R out.

Oct 17, 2008 | Yamaha Mg82cx Stereo Mixer

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

4861 Answers

The Knight
The Knight

Level 3 Expert

72640 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...