Question about Whirlpool ARC4030 Stainless Steel Top Freezer Refrigerator
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: freezer cold but not fridge
too much ice bulid up will stop enough cold air being blown into the fridge.Try turning it off letting all ice melt then turn it back on again and set thermostat at a lower temp.There may be ice you can't see.
Posted on Oct 08, 2008
Check the compressor with a volt meter, if the compressor is getting proper voltage then check the relay. But this sounds like a problem with the compressor
Posted on Feb 12, 2009
I had probably the same problem. After a little discussion with the factory they sent a technician as a "Good Will Gesture." The technician told me it was the control board down by the compressor. I overheard a conversation between he and his central repair office that it was a common problem. The factory would not admit it. I have a feeling the electronic control board he replace (which would have cost several hundred bucks) was probably made in China. Now I'm having more problems with my Ohio made Whirlpool side-by-side. The freezer is working fine, the fridge is not very cold. By the way, the internal lights was one of the keys to the problems.
Posted on Jul 10, 2009
Tips for a great answer:
Jun 17, 2012 | Whirlpool Refrigerators
Jul 17, 2017 | Whirlpool ARC4030 Stainless Steel Top...
Mar 07, 2011 | Whirlpool 25.6 cu. ft. Side-by-Side...
May 28, 2010 | Kenmore Elite 22.4 cu. ft. Bottom Freezer...
Apr 15, 2017 | Whirlpool ARC4030 Stainless Steel Top...
Apr 17, 2009 | Whirlpool 21.0 cu. ft. Top Freezer...
Aug 29, 2008 | Refrigerators
May 16, 2008 | Whirlpool 25.6 cu. ft. Side-by-Side...
723 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: