Question about Dishwashers

1 Answer

The inside of my dishwasher is very dingy, how can I get it to sparkle white. I'm talking about the actual racks to load dishes on?

Posted by on

  • Michael Thibodeau May 11, 2010

    Are the racks rusted? Discolored?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

May just have to replace the racks.

Posted on Apr 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

White film left on dishes and dirt still on silverware


the problem is hard water actually. go to www.dishwasherfilter.com. they have a product out now that solves this problem once and for all. it filters the water going into the dishwasher. after one load your dishes will sparkle again. awesome and affordable product. it even has a money back guarantee.

Mar 26, 2010 | LG LDF6810ST Stainless Steel Built-in...

1 Answer

Top rack washer arm isn't spinning and therefore not cleaning dishes in top rack, bottom works fine


You can replace the whole top assembly. And before you run the cycles again, try putting a cup of Tang (dry) orange juice through the cycle without any dishes or get some Dishwasher Magic and you'll have a sparkling new dishwasher once again! hope this helps you!

Aug 14, 2009 | Dishwashers

2 Answers

Fisher Paykel Dishdrawer - White residue buildup inside


dishes dont seem to be coming clean. they have a film on them. i tried jet dry and still not coming clean

Jun 29, 2009 | Fisher and Paykel 23 in. DD-603SS Built-in...

2 Answers

Maytag Quiet Series 100, Model # MDB5600AWS, built in dishwasher. Does not get the dishes clean, dishes stay dirty after multiple cycles of washing. Please help!


We also have a Quiet series 100 and had the same problem, the dishes always came out dingy or with food all over them. My washer is about 5 years old and worked well for about 4 of them but the last year has been doing a poorer and poorer job washing the dishes. I finally broke down and removed the racks and all of the plastic parts from the inside of the washer. Doing this revealed that the groves in the under side of most of the plastic parts was clogged with food and debris. After a good scrubbing with water and a brush then reassembly it worked like a new washer again, cleaning the dishes very well and the best part is it saved us about $700.00 for another washer.

Jun 20, 2009 | Whirlpool GU2400XTP Built-in Dishwasher

2 Answers

Dishes not rinsing well,


I would check the bottom drain area. Sometimes food can stay down there and block the drain or get back around onto the next load.

Apr 06, 2009 | Kenmore Dishwashers

2 Answers

Motor and pump replaced still not getting dishes clean


Place a cup of vinegar in top rack corner (upright) and run an empty cycle to clean any build up.
Stop using any rinse-aid (jet-dry etc.), if the detergent you're using already has it included. Too much rinse-aid can create a white film on your dishes. A good way to check for rinse-aid build up is to run your fingers on the inside of the cabinet and check for a white powdery residue on your fingers. You can also run the dishwasher for a couple of minutes and check for excess suds in the water when you open it. Excess suds would indicate a rinse-aid build up.
Run the hot water at the tap before starting the cycle and make sure it's at the recommended temperature (120-140°F).
Good luck!

Mar 05, 2009 | Whirlpool GU2400XTP Built-in Dishwasher

1 Answer

GE dishwasher GSD2200G00WW dishes not clean


Make sure the spray arm is actually rotating and the jets aren't clogged. You should be able to hear the arm rotating when the dishwasher is operating.

Otherwise, perhaps the pump is plugged or not working and the water isn't "jetting"

Sep 06, 2008 | GE Nautilus 24" Built-in Dishwasher

2 Answers

Water not draining out after wash cycle


frigidaire dishwasher model#MDR251RER0/serial#TH84453602 not completely draining. I hear when it the drain cycle begins but does not empty completely out.

Jan 05, 2008 | Frigidaire 24 in. GLD2150RCC Built-in...

2 Answers

New dishwasher leaving powder residue on dishes.


the problem is hard water and there is a new product out called the dishwasher filtration system. it actually filters the water going into your dishwasher and leaves your dishes spot free. after the first load i was amazed that the white film was gone and my dishes were sparkling. you can get it at www.dishwasherfilter.com.

Sep 06, 2006 | Kenmore 13869 / 13864 / 13862 Dishwasher

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...