Question about Universal Remote Control MX-3000 LCD Touchscreen Remote Control

3 Answers

Mx3000 does not charge when in cradle. nothing

Mx3000 does not charge when in cradle. nothing seems to be broken

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 10 Answers

I agree with ceocass, however if you find that the contacts are clean and you have made certain that the charging cradle is plugged in you may simply need to replace the battery.
Please note that the replacement batteries for the MX3000 Universal Remote Control, p/n's Powercard PC046067-H & PC036067V3 have been discontinued.
TheBatteryStore.com now carries an alternative battery, p/n PL056067V3 which is a 2,100 mAh typical capacity battery that can be used as a replacement.
Please confirm that the connector type is the same as your battery prior to placing your order. We only carry this battery with the Version 3 connector which has a built in pressure release tab.
The link for the product page is: http://www.thebatterystore.com/replacementbatteryforuniversalremotemx-300037v2100mahli-ionpolymerrechargeable.aspx
If you have any questions please contact TheBatteryStore.com at sales@thebatterystore.com.

Posted on Jul 29, 2010

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 59 Answers

If contact are fine then it sounds like the battery. Here is a site that sells PC046067-H batteries for the MX-3000 remote (battery part #'s that it replaces are BTPC56067A, PC046067H & PC046067-H). I get all of my specialty batteries here and I always recommend them. Here is the link to the site: PC046067-H Battery Replacement for MX-3000 Remote

Posted on Jul 18, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 100 Answers

Clean the conections on the remote and charger that might help

Posted on May 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mint Plus Turbo Charging Cradle won't function properly


Cradle and contacts are fine. Cradle circuit is nothing but a reed relay and few wires, relay closes on proximity to robot's body, therefore no voltage on contacts before robot is close to cradle.
There is a thermistor inside of battery, and mine was bad. I removed it and now I am charging the battery from my bench power supply at about 220 ma current, overnight, and it works. Probably the solution is to get a new replacement battery, but the one with the thermistor inside (OEM), easily recognized by the third wire, and all should be fine, assuming that nothing else is wrong with charging circuit or power adapter (12v/1A)
Hope this will give you some ideas of where to poke.
Once successful, please post your solution.

Jan 19, 2013 | Mint Plus Turbo Charging Cradle

2 Answers

My Logitech Dinovo Edge is not recharging. When I put it in the charger the battery charging indicator light flashes red instead of green.


Were you having problems with short battery life before this happened? Most of the time if the battery is not recharging it needs to be replaced. Have never seen the red flashing light before though. It may mean that the battery has shorted out.

Jul 24, 2009 | Computers & Internet

1 Answer

Garmin 305 wont power on, wont charge on cradle


Same thing happened to mine. Put the unit in the cradle (just like you are going to recharge it) and press the reset and mode button at the same time for 3 seconds. This will "wake" the unit up.

Mar 30, 2009 | Garmin Forerunner 305 GPS Receiver

1 Answer

I have a 605 wifi and it sits in the charging platform. I cannot get it to turn on past the Archos titile page and then it seems to fade and fail like there is no power. It is only 8 months old. Is the...


Hi have you got your power supply plugged into the charging platform??, It would appear you have insufficient charge in the batteries on the 605.
If you have the USB lead plugged into the charging cradle this would normally ask you to select either charge or usb.
What does the CHG. light on top of the 605 do when you plug the unit into the cradle ?? (steady green-- charging. flashing green-- fully charged)

Dec 03, 2008 | Archos 605 WiFi Digital Media Player

1 Answer

MX3000


Please note that the replacement batteries for the MX3000 Universal Remote Control, p/n's Powercard PC046067-H & PC036067V3 have been discontinued.
TheBatteryStore.com now carries an alternative battery, p/n PL056067V3 which is a 2,100 mAh typical capacity battery that can be used as a replacement.
Please confirm that the connector type is the same as your battery prior to placing your order. We only carry this battery with the Version 3 connector which has a built in pressure release tab.
The link for the product page is: http://www.thebatterystore.com/replacementbatteryforuniversalremotemx-300037v2100mahli-ionpolymerrechargeable.aspx
If you have any questions please contact TheBatteryStore.com at sales@thebatterystore.com.

Sep 22, 2008 | Universal Remote Control R7G Remote...

2 Answers

My sidekick 3 won't turn on


Jake-

That is the right button. The charging port is probably bad. This is a common occurence on sidekick 3's. Does the orange light come on but it nevers seems like it is charging?

The best thing to do is get a edocking cradle that has an external battery charger. It will allow you charge the battery seperate form the phone.

See link below

http://fixmysidekick.com/shop/repair-replacement-parts-for-sidekick-3/Sidekick-3-Spare-Battery-Charger

Sep 10, 2008 | T-Mobile Sidekick® 3 Cellular Phone

2 Answers

Dynamic Entertainment System MX3000 - Frozen!


I have the same problem with my MX3000 entertainment system battery by PowerCell P/NO: PC046067-H. Need a replacement battery.

Feb 07, 2008 | Universal Remote Control MX-3000 LCD...

5 Answers

Dynamic entertainment system mx3000


what kind of battery does this thing take?

Nov 06, 2007 | Universal Remote Control MX-3000 LCD...

1 Answer

Mechanism Error - Print Cradle won't move! - HP 5650


This "plastic strip" is called the "carriage encoder strip". This strip dictates the timing of the carriage assembly. If the end slots aren't broken, you can re-attach it. Otherwise, you'll need to replace it. They are about $10.

Jul 03, 2007 | HP DeskJet 5650 InkJet Printer

Not finding what you are looking for?
Universal Remote Control MX-3000 LCD Touchscreen Remote Control Logo

Related Topics:

392 people viewed this question

Ask a Question

Usually answered in minutes!

Top Universal Remote Control Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73619 Answers

Computer Repairing
Computer Repairing

Level 3 Expert

14641 Answers

Cindy Wells

Level 3 Expert

5056 Answers

Are you an Universal Remote Control Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...