Well i want to change my cover on the nds and if i open the cover and change it then put the new cover back on will it affect the nintendo? because i don't know if i have to get some tools to help me or not beacause the system might be tricky.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
this happened to me. all you have to do is take the card out, turn the ds on (without the card), go to the options, click n the calender and set the date back about a year. thats what i did with my ds and i fixed it.
This happend to my sons, the only way i could solve it was to remove the R4i. On the dis mene go to settings, date, then turn the date back by a year or so....
It must be a virus as my sons will not work on dates past 14/4/2010!!!
Hope this helps
You have to update de firmware of your R4 card (I just tested the new version V1.16b for mij R4i and the bug is fixed). For the time being you can change back the date before the 14th of April and you can play directly.
all you have to do is go into the options and click on the calender. set is back about a year and that should fix it. if u only set it back for 2 days the problem will most likely come back in 2 days
best of luck.
most likely its the top screen ribbon.Because when you open the ds all the way it might push the ribbon in just enough to be read but when not open it cant read the top screen and it will shut down.I have instructions on how to change a top screen you can use them to put the ribbon back in. the only difference is you don't need to unplug the white and black wires.First you need a tri wing screwdriver and a cross screwdriver.You can
get both on ebay.Then their are seven screws four tri wing and three
cross.You will need to pry the back off be very careful.Start on the
side that doesn't have the on off switch and work your way around.Once
you have the back off unscrew the two cross screws that hold the logic
board on.Then unplug the white and black wifi
and mic wires they snap on and off.Then flip the logic board over by
pushing the bottom screen out.On the other side is where the ribbon for
the top screen is.To get the hinge apart their are two more cross
screws in the top left corner take them out that releases the
hinge.very carefully roll the ribbon so you can get it through the
metal ring and the wires pull the wires first.to get the top apart the
four cross screws are above and below the speakers
under those small squares.A needle will get them out easily .Once you
get the screws out then slid the back of the top up 1/8 of an inch then
pull the back off carefully.You need to push the screen out and
unsolder the speaker wires or use new ones.Make sure when putting it
back together you roll the new ribbon the right way look at the old one
to find out .Getting the old ribbon out and the new one in is a little
difficult so take it all apart first and get the wires out then the
ribbon and put the ribbon in first.
to reset the ds to factory settings, you will need a screwdriver. on the back of the ds is a little panel, just unscrew that, take the cover off and that that should reveal the battery pack. then all you need to do is take out the battery for a few seconds and stick it back in. put the cover back in and the next time you turn on the ds you will need to input all the data again as if you bought it for the first time.