No instructions for hood 52363 - Kenmore Italian Design 52363 Kitchen Hood

Just look this youtube video, and it can't be more clear.
Don't forget to unplug the hood, or switch it of. Although the halogen lamps are only 12 volt. In the hood are dangerous voltages. How to replace cooker hood halogen bulb or lamp

http://faberonline.com/technicalspecs.html for instructions on all models, thanks

Pull the hood latch

installation sheet:
http://www.mieleusa.com/manuals_pdf/Residential/Hoods/DA408_DA409_Install_sheet.pdf

operating manual:
http://www.mieleusa.com/manuals_pdf/Residential/Hoods/DA408_409_us.pdf

over the stove. instructions should be in the box. follow the instructions and you will be okay. If not call any repair shop or handyman service and they should be able to do for you.

Grease Filter Saturation LED The speed 2 LED in Figure 1 in is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned after 40 hours use. Follow the instructions for cleaning filters in thisFollow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset the display by pressing button A for

frigidaire.com/manuals

This is a straight forward wiring project involving 110 volts of electricity and a 15 amp circuit.

If there is already power available at this location use it. If not, run a wire to the cabinet above the hood location with enough extra to drop down into the hood area and hook it up.

Once you have the power wire in place it is just a matter of hooking the wires up black-black, white-white, ground-ground screw.

enjoy your new hood.

Hi,
I have the same problem with a Phil and Ted's Sport - but I believe I have the solution as below. This is taken straight from the Instruction Manual which you can view at: http://www.arango-design.com/Phil-Teds-Sport-Buggy-p/7890-0001.htm - towards bottom of page is a link to the instruction manual - which I was unable to get on the Phil and Teds website. Got this today but haven't tried it yet. Hope this helps.
Really becomes clear when you see the pictures in the instruction manual.
Regards, John
Hood
The sport hood is packed disconnected.
To reconnect:
1. Locate sun hood and hold it facing down, as shown ‘a’.
2. Insert crimped wire ends into frame, through eyelets, ‘b’.
3. Lay hood back (to top of buggy).
4. Locate red coloured pocket at top of fabric seat and insert rear hood wires into each side, ‘c’ and ‘d’.
5.Open hood and attach domes, at bottom of hood, to main seat, ‘e’.
6. Pull eyelet at top of hood over pegs on each side of frame, ‘f’
Note that the windows in the hood are lined with a sun mesh of
a lower shade factor than buggy fabric. Always use sun cream
and clothing for protection of children in direct sunlight.

You should be able to find the manual here:

http://www.managemylife.com/mmh/owner_manuals/13409/KENMORE-ELITE-Range-Hood-L1004363?brand_name_search=kenmore+50303

The file name is L1004363.pdf