Changing the door gasket on Hotpoint Ultima WD860

Check your water connections. Chances are, you've got a leak that's hitting your electrical connection at some point and shorting it out.

Hi!

Please disconnect your WD860 from the power supply. The door lock uses electrical power to stay closed. After you unplug the machine from electrical power, just wait a couple of minutes and the door lock will be released.

Regards,

Bogdan

open door and caerfully check right round the door seal this is very common on these machines.if ok unplug mach remove lid and check the hose from soap dispencer and tub this sometimes splits .cheers

Hi.
Go to the following site for the info you need.

WWW.HOTPOINTSERVICE.CO.UK

In the menu on the left, click on---Hotpoint user manuals.

In the search box on the right, enterr your model number in CAPITAL letters, and without any spaces, then download the instructioins to your hard drive or printer.

Try the link below...

http://dl.owneriq.net/4/4d301f34-542c-44cf-b7e5-d25c121944a2.pdf

hello if you take the top off the washer and look down inside you should see a metal ring with long screw and nut unscrew this so it's loose you should be able to pull the seal off .then on the front of the washer where the next part of the seal is theres another rmetal thin bit of wire . unscrew the platic clip and the wire should come off. then just pull the seal out of the washer and when you put the new seal on fit it the same way you took it off good luck ps get back to me if you get stuck

shaun

you need to clean the draw and the inside of the draw and clean the rubber door seal all way round when you done that use a washer clean detergent whitch should be at a super market. and run it at 90 or 95 temp cottons wash it should stop the smell beacause dirt is buliding up so a good clean should stop it.hope this helps.

F 05 IS A PUMPING PROBLEM CHECK IF FILTER IS AT BOTTOM FRONT R H S.CLEAN OUT AFTER EMPTYING.IF NOT AT FRONT IT IS LOCATED AT BACK OF MACHINE IN PANEL AT BOTTOM . THE FILTER IS IN THE BLACK HOSE COMING FROM TUB. ++++ REMOVE PLUG BEFORE DOING ANY OF ABOVE +++++

Try the following, may work:

1. Press the Start/Cancel button together until all the console Led's illuminate
2. Press both Start/Cancel and On/Off buttons together until 'd off' appears
3. Default screen should return and you can select a new programme

Hi.
You need to remove the front console panel and then the front panel to change the door seal.

Pull the dispenser drawer out and remove the screws.
Slide the console panel to the right and support it while you remove the rfont panel.
Change the seal, and reassemble in reverse order.

Good luck.