Re: Hi I need a service mode code for a ricoh cl 7100
Press and hold both arrow keys for 5 seconds, let go then press enter. This will enter service mode. You will need to search through the menu system for the particular option you want.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Bizcopier.myhttps://bizcopier.my > Information
To enter service mode, press the yellow Clear button, then 1-0-7. Then hold down the red Stop button for about 5 seconds. The screen will shift to a menu.
if you want all the codes you have to download a service manual or get it from a Ricoh technician, is there a specific code you are looking for? the most common one is code 5 810 to reset error codes.
Hi There,
if you want all the codes you have to download a service manual from the internet or get it from a Ricoh technician, is there a specific code you are looking for? the most common one is code 5 810 to reset error codes.
After doing any of the following, print
ten jobs or more to see if the same SC
code is displayed:
1. Turn the main switch off and on.
2. Check or replace the cable
connecting front (for C&M) or rear
(for K&Y) synchronizing detector
board and the LD unit.
3. Check or reinstall the front (for C&M)
or rear (for K&Y) synchronizing
detector board.
4. Replace the front (for C&M) or rear
(for K&Y) synchronizing detector
board.
5. Replace the laser optics housing
unit.
6. Replace the BCU.
If a synch. detector board cannot be
replaced, do the following as a
temporary measure:
• Disable main scan length detection
(SP 2-919-001)
sc386 = an error with the black developer. This could be caused by something in the DV unit itself, or the black toner. If you've just replaced either one of these recently, try reinstalling them and resetting the machine. Otherwise, the black development unit probably needs to be replaced.
Change the thermistors in the fusor (2).
1. Press the Clear Mode key.
2. Use the keypad to enter .107..
3. Hold down Clear/Stop for at least 3 seconds.
4. Enter the Service Mode.
Turn off and on the copier to reset the code.
Thanks for using FixYa. Error
Code SC726 means the Finisher
shift tray 1 lift motor error. You need to enter service mode and reset the unit by following
the instructions given below. To enter service mode (SP): Press
the clear mode key then enter 1-0-7 hold down the c/s for three seconds. To
enter the special service mode you’ll need to hold the # key down while
pressing Copy SP.Exit service mode: by pressing exit twice. It will reset the and cycling the power.
Please do rate the solution and
revert for further assistance.
fuser oil is a necessity in ricoh machine, it is entirely different consumable than toner (cyan) you dont need to repair the unit only to add oil or fuser oil, pls contact your supplier to buy one and install asap
×