Question about Jackson 25 in. TempStar HH Free-standing Dishwasher

2 Answers

Dishwasher will not run through cycles.

You close the door down and it will not do anything.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Please put the dishwasher fan and clean

Posted on Apr 04, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

This is a Tempstar Higher Hood. Their is a magnet on the inside of the door. When you close the door it comes in contact with the door switch on the side of the unit. That magnet slides freely on the inside of its casing, so it is probably just out of line. Its just poor engineering. The power light comes on right. I know you can't do this all the time, but pull the side door out by handle and see if it starts to fill. Or just slam the door down.

Posted on Apr 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

Door opens itselv after closing


most likely the down stop is set to low, the door hits ground and reverses. so either change the down stop position or increase the down force so it will not reverse upon contact.

Dec 06, 2015 | Building Materials

1 Answer

92 Toronado headlight doors don't seem to stop when doors are closed.


I would check the headlamp door open and close relays first. One or both of them may be bad. It might be a bad headlamp door motor assembly as well. Is there anything blocking the doors from closing all the way? Have you tried closing and opening them manually? You can remove the rubber boot from the door motor knob and turn it by hand.

Apr 10, 2014 | 1992 Oldsmobile Toronado

1 Answer

Model #DU1015XTXS2


With the dishwasher door closed and the unit in standby mode or with no cycle selected and all lights off, press - heated-dry, normal, heated-dry, normal buttons in that sequence. Then press cancel..... wait until 2 minute cycle is done. Open and close the door and make sure it is closed. Then run another cycle.

Apr 06, 2014 | Whirlpool Dishwashers

1 Answer

Oven door doesnt close well


I'm not familiar with your oven but most oven doors are very similar in operation. When the door doesn't close well it's generally because the hinges have been stretched/bent when the oven door has been open. To see if this is the case, open the door fully. If it's stretched the door will open past 90 degrees (slope down instead of being horizontal). The easiest way to fix this is to bend it back. Place something as a spacer between the door and the oven on both sides (like a spanner handle or anything strong and about 8mm thick) as close to the hinge as possible. Close the door against it carefully and push the door closed. Do it a little at a time and remove the spacers and try the door each time until you are happy that it closes nicely again. It should be spring loaded closed slightly.

Aug 14, 2013 | De Dietrich DOC310 Electric Single Oven

1 Answer

Dishwasher door will not close properly


usually d/w doors are fine for long time.
1. check if anything blocks it to close securely e.g. the cutlery basket or the dish racks not fully sliding in or may be off track/chanel.
2. try running a cycle empty and see if it closes after doing #1.

Jul 25, 2013 | Neff S51M53X0 24 in. Built-in Dishwasher

1 Answer

Are lights supposed to be on when the dishwasher is running and the door is closed?


The buttons and the display panel are not lit when the machine is running. This is to save energy according to frigidaire. I wish I had know this before purchasing it about a year and a half ago. The cycle count down timer was a big reason I purchased this one, but what good is it if it only works when the door is open?

Jan 15, 2013 | Frigidaire FPHD2491KF Dishwasher

1 Answer

Garage door will not stay closed. hit remote button when door is down to keep it closed


Assuming that you do not have anything interfering with the obstruction sensor located at the bottom/sides of the door opening, you most likely will need to adjust the "force-down" control. This control switch should be located on the power-head of your opener. An arrow should indicate direction to turn to increase the force down. You must be careful not to increase it too much or you will create a crushing danger for pets and children. Turn only a little at a time until a test keeps the door closed. You must then place an obstruction under the door (1 inch tall) to make sure it still reverses when an obstruction is met. Sometime temperature conditions will affect the correct operation of the opener and it will need readjustment.

Aug 20, 2012 | Home Security

1 Answer

RE: Miele dishwasher G1472 The door will not close. Does the lock work with a relay, or is just the plastic lock broken down? I should like to have a repair manual of this machine. Where can I find it?


Sorry mate - manuals are hard to come by from miele, only service agents have these and are bound by contractual obligations.
there is a door locking plate located mid top of the dishwasher which latches to the door, a locking mech. # 6022271 located on the door itself.
The locking mech is electrically controlled only when cycles are selected and you push start. The chances are where the latch system which clicks into the mech is likely to be worn or jammed, the door should click into place as you close it and electrically locked during the cycle.
I would say there is a mechanical problem with the machine more so than anything else.

Jul 04, 2011 | Miele G 1472 SCVI 24 in Builtin Dishwasher

1 Answer

My tunk door on my 95 deville will not close, i use to push down and it will close alone, i push down it does not grab anything.


The gear is either stripped or the unit is bad, Try getting the unit, motor and all from a junk yard and exchange and this will fix the unit and pull down.

Jun 27, 2011 | 1995 Cadillac DeVille

1 Answer

Ok so I am having a problem with craftsman garage door, The sensor light are right on green and one orange, but i still have to hold down the button in the garage to shut the door. Also today i thought...


If when you try to close the door the main light flashes 10 times and the door starts down and then reverses to the open position you have a door sensor problem. Make sure the lights in the sensors are not flickering ever so slightly. The color of the lights doesn't mean anything. The keypad sounds like a separate problem. Make sure the battery is good.

Apr 07, 2011 | Sears Craftsman LiftMaster Chamberlain...

Not finding what you are looking for?
Jackson 25 in. TempStar HH Free-standing Dishwasher Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jackson Dishwashers Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

jhnolson

Level 3 Expert

749 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Jackson Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...